Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Avatar
Aussie
Member
Last Activity: 08-28-2014, 07:13 PM
Joined: 08-25-2014
Location: Melbourne
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Re: Samsung UA46B7100WFXXY

    Ive stripped the Tv down to expose all tabs now....I have been over each tab, manipulating it...rubbing joins with a chiseled chop stick whilst set is on...
    I can not bring on any change, should I be able to?
    I hope you don't feel I am wasting your time here..I currently have some time to waist so i dont mind playing around with it trying what i can....
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY

    I figured I may have a fault from this tv being stored resulting in poor conduction as well as original fault....What is a BGA? excuse my ignorance, but i don't understand why i can run the panel with a varied outcome over extended periods...it does not make sense to me...electronics are either faulty, or not....
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY

    Ok Tom, although I am accepting the possibility that I have a bad panel here, I am also sceptical due to the intermediate problems I am having here...Ive now gone and switched it on and its come back to a full picture...not perfect no...but not green

    This make me wonder if there is a bad IC somewhere....I have done somersault's with this thing today...and everything i do seems to make it do something different...

    In a perfect world i could just swap a few boards in and out, but are there some tests i can do on these circuits'...
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY

    I reset all ribbon to T board and got picture back...hoping to possibly improve again I reset them again, and now back to green screen....
    Its a bit of a head ache handling a 46 inch tv.....
    I would be very grateful if someone could be of more help...
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY



    G'day Tom, Do you mind if I ask what is "this" problem?...
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY



    Thanks for the link there, that was helpful...I will look at that next...

    As far as ordering any new boards, I will not be doing that unless I am certain I have located the problem, I normally repair audio circuit's. I've not done much TV or surface mounted board work though and I am still a learner....

    Currently back to Green screen!...
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY

    This is how good the picture was before i took it into the house.....it was clear like that for a good ten minutes...still very fine horizontal lines though....if you stand back its not obvious.......
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY



    If this has been heavily discussed on this forum before and I am trying to flog a dead horse here, would you mind linking me to the thread?...
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY

    Although there is information on the Power supply board regarding voltages, I am unsure what to match to the rails leaving that board....
    I did however note several at 5.2v, couple at 12v BUT, one at 2.2 v...this seemed odd to me?
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY

    just some more info, after again removing power supply board and rechecking caps, resistor values and diodes I then re installed....
    after reinstalling the green screen returned again. i shifted it off the bench to do something else at that point.
    when i set up again i didn't realize at first i had placed set upside down....I didn't bother flipping as i only intended to test voltages...But it came back to a picture again.

    I then unplugged again and flipped the right way up, when i turned it on i had the clearest picture ive...
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY



    Could you explain what you are talking about here? or possibly direct me to another thread on this topic?...
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY

    Hmm ok, well I hope its not the screen...I would still like to be sure though before I discard it.....
    So this morning I powered unit up again via power board switch and the green screen returned....powered off again and re checked ribbon, then back on via power board...still green, I then turned it off and back on again via power button and got picture back....still with other issues shown....

    I have now been over boards with electronic freeze spray with no changes....is there a service manual for this this so I can check voltages?...
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY

    If that is the case, would the same problem not present its self all the time ? picture gets worse about a minute after powered on
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY

    No clues ?
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY

    I know the power board is loaded with cheap caps and I would like to replace these., although they all test ok.....But I am hesitant to move forward at this stage until I have more information regarding this model....
    See more | Go to post

    Leave a comment:


  • Re: Samsung UA46B7100WFXXY

    Here are some Pictures of screen and boards for reference......
    See more | Go to post

    Leave a comment:


  • Samsung UA46B7100WFXXY

    Hello everyone, I know this is only my second post but I do intend to spend some time on this forum and hopefully add as much information that I can..

    I like to repair audio equipment normally but would like to learn more about TV repair.
    In my travels today I picked up one of these TV's....
    So far...Green screen, I cleaned ribbon cables and now have picture.
    I now have horizontal white stripes across full screen, kind of like looking through lines..
    So I re cleaned ribbon connections and seems the lines are a little tighter...
    still not the problem...so...
    See more | Go to post
    Last edited by Aussie; 08-25-2014, 04:07 AM.

  • Re: New Members - please post your introductions here

    Hello everyone, I am pretty new with electronics. Have been studying for a bit over a year now...I would like to improve my trouble shooting skills. Hopefully you guys can help me!
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X