Re: Chimei CMV 938 D
Finally got some time to get the tests done. The results were about 760 Ohms on both S1-S2 and S3-S4.
limkopi
New Member
Last Activity: 11-27-2015, 03:16 AM
Joined: 06-15-2014
Location: Singapore
-
Re: Chimei CMV 938 D
It still does 2 seconds to black after replacement. Power LED stays lit. Picture dimly visible
Not sure what CFL Lamps are and how I should use them for tests.
picture of back of power board attached. I hope this is clear enough....Leave a comment:
-
Chimei CMV 938 D
The monitor required a long warm-up time, until one time when I turned to max brightness for too long. There was a snapping sound and the monitor turned black, with a very dim image still visible. I opened the monitor up and true enough, the caps were bad and all were replaced. Didn't work. The ICs at the blackened spots were replaced, and still didn't solve the problem. The screen was still dim and image slightly visible.
Photo of the boards included....Last edited by limkopi; 06-25-2014, 09:23 AM. -
Re: New Members - please post your introductions here
Found this forum when looking at repair solutions for my monitor.Leave a comment:
No activity results to display
Leave a comment: