Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]

Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Avatar
Davie_b
New Member
Last Activity: 08-17-2021, 04:57 AM
Joined: 06-03-2014
Location: Dublin
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Re: Samsung Model LN46A530P1F LCD display issue

    So sorry for delay in getting photo up,i hope this works my ring hit 1 or 2 of the 4 little fuse types above the left tab in photo,tv still has sound and backlight comes on but picture faded away,when i disconnect left side of t-con and reboot i get half white screen,dont know if it means anything,thanks for helping Alastair,have i destroyed the screen ?....
    See more | Go to post
    Last edited by Davie_b; 03-20-2015, 01:46 PM. Reason: more information

    Leave a comment:


  • Re: Hopefully t-con issue

    Any help is much appreciated,
    See more | Go to post

    Leave a comment:


  • Hopefully t-con issue

    Hello,i have Samsung LE46A756R1M lcd tv,which developed a tab bond issue,i stripped tv down and isolated offending tab top left,put a shim between frame and all was good for two weeks,but it went again i found a repair centre to fix tab bond permanently,to cut a long story short,when i was at the tab top left,i hit the little resistor types on the source drivers board attached to tab,with my ring,and picture faded away,still have sound,what im hoping someone with knowledge can tell me what the knock on effect of shorting the drivers,when i disconnect the side that i shorted i get half white screen,what...
    See more | Go to post
    Last edited by Davie_b; 03-16-2015, 01:59 PM. Reason: more information

  • Re: New Members - please post your introductions here

    Long time lurker,first time poster,excellent site,wealth of information,due to this site have saved lots of tv's from rubbish tip,keep up the good work,
    See more | Go to post

    Leave a comment:


  • Re: Samsung Model LN46A530P1F LCD display issue

    Hello,long time lurker,first time post,i had same issue as original post,decided to have a go at repair,found offending tab,top left,made a shim,worked for 3 days,tried second time and as i applied pressure my finger slipped and my ring hit the tiny resistors behind tab and screen went blank,just hoping someone can tell me whether i have ruined panel or maybe just destroyed t-con,reason i mention t-con is before this happened when i disconnected t-con i got white screen,now nothing happens,thanks in advance
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X