Re: Fsp300-60atv (pf)
I replaced all these caps and with the ps tester everything looks fine : the ps starts instantly like it should.
I bought me a esr meter too ( atlas esr from peak ltd ) and mearured the caps that i replaced : the teapo and jamicon are good and the ones from fuhjyyu are all bad.
1.67 ohm,1.91 ohm,1.81 ohm,4.4 ohm,1.43 ohm.
I will place the ps back in the pc and hope it will last for a long time.
thanks for all the advice.
berreke54
New Member
Last Activity: 09-06-2009, 09:47 AM
Joined: 04-27-2009
Location:
-
Re: FSP300-60PN, failed to start
and here is the right one...Leave a comment:
-
Re: FSP300-60PN, failed to start
here you can find the specs for fsp300-60atv(pf):
it says that the psu will shut down if the loads to +3.3v and +5v lines are not between certain limits
hope this helps
i'm working on that oneLeave a comment:
-
Re: Fsp300-60atv (pf)
i just received the parts and i'm going to replace it next week, i keep you informed later on
thanksLeave a comment:
-
Re: Fsp300-60atv (pf)
thanks for the adviceLeave a comment:
-
Re: Fsp300-60atv (pf)
I wonder if there is a reason why I do not have any replies or advise I asked for??
Leave a comment:
-
Fsp300-60atv (pf)
I have a PC smps FSP300-60ATV (PF) from Aopen with problem to start up.Only after several attempts it starts .
I found several elco's to be bad :
1) (c33?) 4700uF/10v FUHJYYU TMR (M) P10 CE 105°C VENT ø10mm L31mm
located at ?
2) (c32?) 4700uF/10v FUHJYYU TMR (M) P10 CE 105°C VENT ø10mm L31mm
located at the end of 3,3v ( to ground)
3) (c26?) 1000uF/10v FUHJYYU TNR (M) P10 CE 105°C VENT ø10mm L18mm
located at the end of 5v ( to ground)
4) (c23?) 1000uF/10v FUHJYYU TNR (M) P10 CE 105°C VENT ø10mm L18mm
located at ?
5) (c25?)...
No activity results to display
Leave a comment: