Re: Can you help me find replacement Panasonic tansistors?
I have a TC-P55ST30 that has shorted DG301. (to-263)
Can I repl with 30F131.? or with FGD4536tm.?
Which is the toughest one.?
GuyTv
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
I have been a member since April 2014
I never opened a post yet. HOW do I open a post.??
GuyTv
-
Re: Panasonic TC-P50G20 Problem
Sorry about that. Upon checking again, the reason why the "AP" connectors looked different is : The seller must have been a rookie. When the seller removed the SC from his tv, he ripped off the connectors from the SU & SD with the SC plugs. The SU & SD connectors are attached to the SC plugs. That's why the "AP" looked different to the "AF" My apologies to my mistake. I just did remove those SU/SD connectors from the SC & Yes it's running good.
Enjoy, have a good one.!! GuyLast edited by GuyTV; 06-13-2016, 10:05 AM.
Leave a comment:
-
Re: Panasonic TC-P50G20 Problem
I must stress the fact that the TNPA5081AP will not replace the " AF ".
The SC41, SC46,& SC42 are made different. They don't fit on the SU & SD boards. If one wants take a chance in interchanging those connectors, you can try that. I have bought a "AP" to replace a defective "AF" , but I don't want to try the interchange. I will not risk blowing the SC board I just bought.
Interchanging the connectors might work. It's at your risk.
It is almost impossible to find a reliable seller for a "AF"...
Leave a comment:
-
Re: Tnpa5081 af 7 blink error trying to repair
On EBay some suppliers have kits that include up to 31 components, but none of the kit suppliers show to contain the Q818.
Where can I get a kit for TNPA5081 with the Q818 transistor.???
Leave a comment:
-
Re: samsung un46eh5000fxzc
I have a uneh5000 in the shop with LED problem. To test the strips, you must disconnect the right from the left side. You can test the far end section (5-led) by feeding 13.5 volts with a 100-ohm resistor in series. For the 6-led strip, you must short the disconnected ends together & provide extra voltage to run this strip. My dc supply only goes up to 13.5 volts. So, I use two 9-volt battery in series with a 100-ohm current limiter in series , that will light up the strip if it's good. (Just make sure not to over feed the supply voltage)
Count...Last edited by GuyTV; 12-30-2015, 10:15 AM.
Leave a comment:
-
Re: LG 42LGX Mystery Part- at least to me;-)
I have a LG model 42LG60 with small horizontal lines exactly like the attached images [ 1-Horizontal Static.jpg]
Have someone found the cure to this problem yet.?
The mystery board is called the Digital board.
Please let me know if a solution was found..
GuyTV
Leave a comment:
No activity results to display
Show More
Leave a comment: