Hi guys im working on the above tv can anyone tell me what pins i need too bridge on the psu (17pw07-2) so i can tell if backlight section is working thankyou
-
-
Re: polaroid p40led12
Apply 3.2v to blon mate, I’ve had luck with this on ips20 series. The ones for the 55” are set up different though.Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !
https://www.facebook.com/Telford-Tel...7894576335359/ -
Re: polaroid p40led12
Thanks reece i will give this a try.Comment
-
Hi all, I have a polaroid p49fn0038k, I originally thought the problem was just a straight forward backlight replacement, however this isn't the case..
When I power it up, the backlights flash on for a split second, I've tested the backlight strips and all are fine, I can see the polaroid symbol on the screen using a torch light....
Any help would be greatly appreciated
Thanks in advance11-10-2022, 10:30 AM -
polaroid TQLHD24PR004 no power
hi, my tv no longer starts like dead, no standby led
motherboard : MS36639-ZC01-01
panel : V236BJ1-P01
flash spi: GD25Q64
need usb firmware or to reprogram​ -
Good afternoon,
I have a Polaroid P43D300.
It shipped with WiFi and Bluetooth.
Two weeks ago, I ran through the first time installation.
This did a full reset and went through the first time setup.
Once complete, I went to settings > sound.
selected Audio Link, changed setting from disabled to enabled, pressed green button on remote and the tv does a search (discovery) for Bluetooth devices.
search completes and doesn't find any devices.
I have tried everything I can think of.
Can someone provide... -
Hello,
I am looking for the Dump Firmware of this model.
Mark: Polaroid
Model: TQL48R4PR003
Main board chassis: CV9203H-A42
LCD Screen / Panel: 15y_s48ff11mb7s4lv0.1
More information: W25Q32
thank you for your reply -
Hello,
i have an issue with my polaroid TV Model : tql39r4pr002
the standby led is red , and when i turn on the TV it shows the polaroid logo and turns off, also the standby led switches to blue the back to red .
capacitors are apparently ok, i have 320V in the smoothing primary capacitor, and 13V in the diodes in the secondary.
i don't understand why the mainboard switches to this mode and don't turn on.
don't find any service manual for this model ,or the main board schematic. cv9203h-a42
thank you for your help....
Comment