Sony KDL-70W850B T-CON problem
Collapse
X
-
Re: Sony KDL-70W850B T-CON problem
Do you have to pair the Tcon to the mainboard. Diah and Neilc6 may have some information on this that could help.Last edited by dick_barton; 01-22-2021, 03:38 AM.Willing to help but I'm no expert.Comment
-
Re: Sony KDL-70W850B T-CON problem
T-CON replacement dont need any pair at this sony. the T-CON must be 100% for the same model and screen size.. but if the original are defect and it register 5 blinking error ,, then need to clear the error at self diagnose service menu..pairing and adjustments need only if Main boards or tuner replaced..
so..
why you changed the T-CON ??
put back yours yours original T-CON in place and turn on to let the set running normal again..... and show us clear photo on the boards and the issue you have.Last edited by Diah; 01-22-2021, 01:08 PM.Comment
-
Re: Sony KDL-70W850B T-CON problem
The problem of the tv with original t-con is that when tv is turn on works great all day once its to be turn off you cant turn it back on it gives green and orange ligth...i need to unplug it and it will turn on good until its turn off....so did change t-con new and does not come on green and orange ligthComment
-
Re: Sony KDL-70W850B T-CON problem
The problem of the tv with original t-con is that when tv is turn on works great all day once its to be turn off you cant turn it back on it gives green and orange ligth...i need to unplug it and it will turn on good until its turn off....so did change t-con new and does not come on green and orange ligth
firmware start script when the set turned off, there are low RESET at the chips where forced the start script start from beginning. so the set will turn on normal again as last state before it turned off. if this small procedure interrupted because of bad chip ( sector) or there were bad caps which didn't discharged as it need so the chips ( start script i mentioned above ) remain active and didn't reset it self. until the currents drops close to ZERO.
i asked you at my post #6 to put back yours original T-CON so we can start diagnose the issue.. but as usual many just they believe on what they have in mind.. on this way i cant share my help.Comment
-
Re: Sony KDL-70W850B T-CON problem
Hi Diah
Have a few questions , if you don't mind .
Is this one of the earlier Sony models , that use the Linux operating system ?
Is it the later Sony sets using the android operating system that are more particular , with regards to pairing ?
Thank you in advance , Zen.Comment
-
Re: Sony KDL-70W850B T-CON problem
Zen, asking questions is great but you need to start your own thread. If someone stops to answer a bunch of questions in the middle of someones thread, it only takes longer and adds confusion and unnecessary length to the thread. I'm pretty sure Diah knows the answers but this particular thread is for the task at hand, trying to fix this tv. Not that I really care what goes on here, it's just a little distracting.Last edited by nomoresonys; 01-23-2021, 05:40 AM.Comment
-
Re: Sony KDL-70W850B T-CON problem
Hi...i change the main and got it to work...i did the upgrade t-con was fine all the time...now the tv stay on the green ligth and shows pic...but now the no backligth with flash ligth it shows the picture...i see the channels and menu.......Comment
-
Re: Sony KDL-70W850B T-CON problem
But before did the update the backlight were working...first i put the usb with update then i connected to outlet and started alone updating and backligth on with the circle arrow doing his update when it finished turn on and off then back on but with no backligth...but i can see the image with flashligth now it stays green ligth...Comment
-
Comment
Related Topics
Collapse
-
by ChrissygizmoHello again everyone,
This is my latest mission, to try getting this Sony tv back to normal working order…
I've only just got it today, when you power it up everything is as should be, in fact it works perfectly for a few minutes then the screen starts getting horizontal lines on & eventually the full screen goes back, I will upload photos of the problem & also some photos of the board etc. You might notice that I'm busy trying the tape method, I'm not sure exactly where the clock lines are so I'm just guessing & hoping for the best lol . I've already tried... -
by thelankanguyThe TV shows a black screen with no image.
TCON ribbon connectors were disconnected individually for image and there was no half image even.
Later both ribbons were disconnected and TCON voltages were tested.
12V, 3.3V, 1.8V were seen present but VONE signal reads 0V.
There is also a short to ground in this circled inductor.
Is this a TCON issue or something else ?... -
by crackedprintI have a strange fault on a Sony amplifier. The volume control varies the display from MIN, then 1 up to 30 and then MAX as expected. At MIN there is no sound. However, at 1 it is quite loud and increasing above 1 does not change the sound level.
I have tried a Cold Reset as per the service manual.
I have looked at the I2C clock and data to volume control chip IC501 (BD3499FV). Data is only sent to IC501 when the volume is set to MIN or 1. At any other setting no data is sent to IC501.
I have looked all the way through the service manual and tried many online...-
Channel: Troubleshooting Audio Equipment
-
-
by retrorepairHello gurus, hope you can assist me...
I have a Sony KDL.40P3600, with an issue on the left side of the screen (pictures attached).
I think the problem is the panel, but before send it to trash, i would like to get a second opinion.
Thanks in advance.2 Photos -
by YasaChSony KD-49XF9005 it power up to android boot screen and turns off immediately with continuously 4 red blinks ...
- Loading...
- No more items.
Comment