Hello there.
First, excuse me, because english is not my mother language.
So, I have a Tucson TV model TL2204B274 for many years now, and the HDMI never worked.
Let me explain.
I have a laptop with an HDMI output (on Debian Buster), so I can test the output. When I connect via HDMI, it IS detected as a Vestel TV (which is obvious, since the internal board is a Vestel 17MB82S).
But, when I switch source to HDMI ON the TV, it says "No signal" (with the 5min timer).
The sub board which contains the LED and the IR receiver have been broken years ago, but I managed at least to resolder the IR receiver, so remote control works fine.
I tried to update the firmware with the correct instructions, but it DOESN'T update (or at least I don't know, since I don't have the LED.
Note also that I manage to have a "new software" but was a bad one (glitchy yellow screen), but only on the USB, and it only worked ONCE. I managed to find the correct 17MB82S update PKG file, but I CANNOT boot on it.
So, what is going on with my HDMI ? And also how can I update the firmware since it doesn't boot (or once within thousands of trials) ?
Thanks !
First, excuse me, because english is not my mother language.
So, I have a Tucson TV model TL2204B274 for many years now, and the HDMI never worked.
Let me explain.
I have a laptop with an HDMI output (on Debian Buster), so I can test the output. When I connect via HDMI, it IS detected as a Vestel TV (which is obvious, since the internal board is a Vestel 17MB82S).
But, when I switch source to HDMI ON the TV, it says "No signal" (with the 5min timer).
The sub board which contains the LED and the IR receiver have been broken years ago, but I managed at least to resolder the IR receiver, so remote control works fine.
I tried to update the firmware with the correct instructions, but it DOESN'T update (or at least I don't know, since I don't have the LED.
Note also that I manage to have a "new software" but was a bad one (glitchy yellow screen), but only on the USB, and it only worked ONCE. I managed to find the correct 17MB82S update PKG file, but I CANNOT boot on it.
So, what is going on with my HDMI ? And also how can I update the firmware since it doesn't boot (or once within thousands of trials) ?
Thanks !
Comment