Troubleshooting Philips 55 LED TV(horizontal lines and discolouring)

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • keweik
    New Member
    • Nov 2018
    • 4
    • norway

    #1

    Troubleshooting Philips 55 LED TV(horizontal lines and discolouring)

    The TV is a Philips 55pfl5527t/12 where i issue is horisontal lines with weird colours. I've tries to factory reset, hard reset and software update. Did also clean the ribbons connected to the TCON unit. Should i just change the hole TCON?

    Don't have some much with TV's, so where should i start?
    Attached Files
  • Andrew F. Ali
    Badcaps Legend
    • Jan 2014
    • 2450
    • Trinidad & Tobago

    #2
    Re: Troubleshooting Philips 55 LED TV(horizontal lines and discolouring)

    Your photos do not show the problem you are having. Perhaps a different screen when watching a movie or something with a white/lighter scene.

    Comment

    • keweik
      New Member
      • Nov 2018
      • 4
      • norway

      #3
      Re: Troubleshooting Philips 55 LED TV(horizontal lines and discolouring)

      My bad, here are some new ones
      Attached Files

      Comment

      Related Topics

      Collapse

      • rtstorm
        Philips 55PUS7303 LCD lines
        by rtstorm
        Hello, I have this 55" Philips TV that suddenly has these vertical lines on the LCD panel. I have checked the T-con board and I noticed some caps have 40Ohm I don't know if this is normal. These caps have 1.2V on them. I mark them on the photo with a silver pen. The T-con board has 1.2V, 12V, 25V, etc. Does anyone have any idea what could it be?
        i try to disconect one ribon cable and the problem is the same, one side is white other side have the lines (the same is in other way)

        T-con model: 55T32-C0L
        Main Board: 715G8579-M0F-B01-005T
        03-28-2024, 02:55 PM
      • howardc64
        TCL 55S425 few horizontal lines, potential failure on both side of panel/buffer board
        by howardc64
        All left and right refers to looking from rear of TV (or looking from front with TV upside down)
        • TV came with vertical bars and no image. Found faulty TVS on left buffer board. Also replaced T-Con (may have damaged the original while hot air removing components, board has slight warp) and have full image but few horizontal lines on the screen. Some of the lines appears to be 2 pixel tall while others are 1 pixel tall.
        • Disconnecting left and right buffer board potentially reveals problems on both sides with different signals (unless this T-Con require jumper like Samsung FB_TRDY1&3) Fault
        ...
        07-24-2025, 05:17 PM
      • marekk
        Philips 55PUS6754 with lines after few seconds
        by marekk
        Hi,
        I have tried to replace TCON but it didn't help.
        The strange is that it shows Philips logo before the lines. Tried to cover some of the lines with tape on the ribbons to the screen but had no success.

        screen: tpt550u2-eqya3.g
        tcon: 6870C-0769A

        I will appreciate any help

        Many thanks

        Marek...
        11-03-2022, 03:00 PM
      • grandad99
        philips 58PUS8105/12 horizontal lines
        by grandad99
        hi all and hoping i could get some help please.

        my philips 58PUS8105/12 has started acting weird.
        its getting these lines across it and sometimes a strange black half circle sometimes appears on the right hand side edge of the screen,the screen is cool to the touch all the way around except where you get to that black halfcircle about the size of a smartie right on the bezel edge of the screen,its quite hot.
        tv prob 3 years old and only used on weekends for a few hours so not done much.

        i popped the back off and cleaned the ribbon contacts all to no...
        08-01-2023, 10:37 AM
      • Stanley1843
        Screen Display Vertical Multicolor Lines
        by Stanley1843
        Hello, I have a screen in where sometimes when I open it pop-up vertical multicolor lines (I would say the most of them are green). If I tun off and turn on the screen the lines dissapear or if I leave open the screen after approximately five minutes the lines gone. I measured the below voltages on the main PCB and on the T-CON board and the voltages are the same when it doesn’t display the vertical lines and when it displays the vertical lines. Also, I cleaned all the connectors very good with IPA. I moved back and forth the connectors and the COF tabs but the vertical lines didn't displayed...
        06-29-2024, 11:54 AM
      • Loading...
      • No more items.
      Working...