Olevia 232-S12 no pic

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • attainteddragon
    Badcaps Veteran
    • Apr 2013
    • 764
    • australia

    #21
    Re: Olevia 232-S12 no pic

    since you originally had 12v on the fuse on the t-con, and now you don't, it looks like you have received a bad main board. if you put your old main board back in, does the 12v come back at the t-con fuse?
    WHY CAN'T PHILIPS USE PHILLIPS HEAD SCREWS?

    Comment

    • ivtec
      Badcaps Legend
      • Dec 2008
      • 1967
      • USA

      #22
      Re: Olevia 232-S12 no pic

      Originally posted by attainteddragon
      since you originally had 12v on the fuse on the t-con, and now you don't, it looks like you have received a bad main board. if you put your old main board back in, does the 12v come back at the t-con fuse?
      the old Main board is fried, can't be repaired,i replaced a regulator that i thought was bad but put in one that was a adjustable regulator instead of a 1117 and fried a sm cap beyond repair also burned the trace where it was,

      Comment

      • ivtec
        Badcaps Legend
        • Dec 2008
        • 1967
        • USA

        #23
        Re: Olevia 232-S12 no pic

        Originally posted by ivtec
        the old Main board is fried, can't be repaired,i replaced a regulator that i thought was bad but put in one that was a adjustable regulator instead of a 1117 and fried a sm cap beyond repair also burned the trace where it was,
        the SM Cap that burned on the original main board beyond repair see pic,i could replace and solder it to one side where the trace is intact but on the other side close to the small cap there is not trace burned out,if i knew where the trace went to i could solder a small wire to it but i can't detect any trace or component that trace goes to.

        Also i tested the lvds connectors with my Fluke on continuity mode pin one by one put probe on mainboard pin 1 and probe on pin 2,3,4 or any other pin on T-con board and i get short ,my question should it not be open on every pin main board to T- con board pins ?
        Attached Files
        Last edited by ivtec; 09-12-2017, 09:52 AM.

        Comment

        • attainteddragon
          Badcaps Veteran
          • Apr 2013
          • 764
          • australia

          #24
          Re: Olevia 232-S12 no pic

          well, at this point i still feel like you have a bad main board.

          there are several pins on the lvds that are spread across several wires, like ground and power in your case. you would need to confirm which pins are shared and which are not to confirm what you are asking.
          WHY CAN'T PHILIPS USE PHILLIPS HEAD SCREWS?

          Comment

          • ivtec
            Badcaps Legend
            • Dec 2008
            • 1967
            • USA

            #25
            Re: Olevia 232-S12 no pic

            Originally posted by attainteddragon
            well, at this point i still feel like you have a bad main board.

            there are several pins on the lvds that are spread across several wires, like ground and power in your case. you would need to confirm which pins are shared and which are not to confirm what you are asking.
            Thanks attainteddragon; I'm waiting for a T-con board,hope the Main board is not Bad if it happens i will never buy stuff from E-bay,

            I'm relying on pic bellow from LCD T-con faulty that i got from lcd repair tips,and is very similar to mine that is pic # 2
            Attached Files
            Last edited by ivtec; 09-13-2017, 12:47 PM.

            Comment

            • vinceroger69
              Badcaps Legend
              • Mar 2012
              • 6714
              • uk

              #26
              Re: Olevia 232-S12 no pic

              just read the whole thread i too think this is a faulty main board if your certain you have no voltage on the t con fuse

              Comment

              • ivtec
                Badcaps Legend
                • Dec 2008
                • 1967
                • USA

                #27
                Re: Olevia 232-S12 no pic

                Originally posted by vinceroger69
                just read the whole thread i too think this is a faulty main board if your certain you have no voltage on the t con fuse
                vinceroger69;will see,it could also be a short on t-con board that could cause the connections from the main board to bee short circuit

                Comment

                Related Topics

                Collapse

                • Ancient1
                  I have no clue how-to : TV auto-starts with Android no buttons and LED fast flicker
                  by Ancient1
                  CROWN Smart TV, 50", Single board design

                  1. TV starts with Wall power..
                  2. The front LED is blinking very fast that it looks like a red&green LED
                  3. The Android Menu in the photo appears
                  4. Buttons are not responsive

                  I tried few pre_Power Button Combos, and with Power, but none worked

                  I'm scratching my head how to start diagnosing.. ??...
                  10-19-2022, 10:12 AM
                • cadar21
                  olevia - 747i-B11 fw
                  by cadar21
                  hi guys looking for a FW UPDATE FOR MY oLEVIA 47'..
                  the screen is freezing an the audio continues to play...
                  my current fw is
                  --FRW--747-B11_V63.7.5A17 VLCD78310263
                  if that helps...my research leads nowhere...i guess the website is no longer available since Olevia filed for banckrupcty....
                  any help would be appreciated.. looking for the USB fw..
                  Olevia - 747-B11
                  FM1-04700E-S00
                  12-13-2017, 03:13 PM
                • hispeck
                  Olevia Tv Lt23hvx service manual
                  by hispeck
                  Hello all, I need help on olevia tv service manual. The model Lt23hvx
                  12-03-2018, 05:12 AM
                • Cory Meyers
                  🤯 Acer Predator Helios 300 pH315-54
                  by Cory Meyers
                  Hi there all, 1st post here. I wasn't aware there were guys out there doing this for people! (how, well I haven't a clue lol but 😎👍 badass!), So when I found y'all, I was happy, but not too happy quite yet - although my issue seems to be less severe than many I've seen here who have been happily helped, so there's that.

                  I'm a software dev of over 20 years and just recently have gotten into the hardware side of things plus other electronics like Rpi and Arduino. Started off a vid game hacker yada yada, same story. Lol.

                  Now, the BIG OL' issue ruining me little life:...
                  10-28-2024, 05:11 PM
                • Michale32086
                  THE HULK Olevia 265TFHD 65" LCD Inverter Boards ???
                  by Michale32086
                  Got in a monster.. Older Olevia 65" LED and the thing weighs like 500 lbs!!

                  OK, OK, only 235 lbs but it feels like 500...

                  Power it up and, after a few tries, it comes on.. No backlight on the left side of the screen, as you face it..

                  So I am thinking bad inverters.. It's a set of 3 on either side..

                  Ordered a replacement set, but they came in damaged.. Specifically, the metal frame that surrounds the doo-hickeys.. (see pics)

                  Would that affect functionality??

                  Thanx...
                  07-31-2018, 06:38 AM
                • Loading...
                • No more items.
                Working...