le32c530f1

[jonny78]

hi guys..picked up a le32c530f1 for free been testing this for sometime and everthing works great...picked up a remote for this set today and it just refuses to work...remote is an official samsung one and the right one for this model... and works fine but will not control the tv...all of the touch sensitive buttons work on the tv and the standby light works etc...ive took the back off the tv and found the part for it :

http://www.ebay.co.uk/itm/BN96-13451...-/301969879082

dont really want to be paying money out on this set..any advice as to why the tv wont allow me to control it with the remote?

cheers

[dskall]

Re: le32c530f1

Bad ir sensor?

[dick_barton]

Re: le32c530f1

Check that all the cables are connected especially the one from the IR board.

[Andrew F. Ali]

Re: le32c530f1

How do you know if the remote you received is good or not??

[jonny78]

Re: le32c530f1

Bad ir sensor?

yep more than likely! would there be any fix wihout replacing the whole module.? the whole module is far to expensive and isnt worth it..like i said all of the pressure sensitive buttons work etc just wont work with the remote!

[jonny78]

Re: le32c530f1

How do you know if the remote you received is good or not??

hi..ive tested the remote on somebody elses tv which is the same model and it works fine!

[jonny78]

Re: le32c530f1

Check that all the cables are connected especially the one from the IR board.

Done that still the same! i just dont want to replace the whole module because as you can see by the link on ebay its finacially not worth doing so!

[attainteddragon]

Re: le32c530f1

if you check the dc reading on the output of the ir sensor, you will see if it is sending a signal when it gets a command from the remote.

you can change out the ir sensor with another from a scrapped set, but sometimes the pinout is different and you need to rearrange the legs a bit to get it to work.

[dick_barton]

Re: le32c530f1

The above ebay link says BN96-13451B = BN96-13022B = BN41-01382A Control panel Samsung Function Board

http://www.lcd-plasma-parts.co.uk/<b...XU-BUTTON-UNIT

£3.99 + VAT

[attainteddragon]

Re: le32c530f1

The above ebay link says BN96-13451B = BN96-13022B = BN41-01382A Control panel Samsung Function Board

http://www.lcd-plasma-parts.co.uk/<b...XU-BUTTON-UNIT

£3.99 + VAT

dam, how could anyone turn a profit when you have to spend coin like that to get a tv up and running?

[Andrew F. Ali]

Re: le32c530f1

if you check the dc reading on the output of the ir sensor, you will see if it is sending a signal when it gets a command from the remote.

you can change out the ir sensor with another from a scrapped set, but sometimes the pinout is different and you need to rearrange the legs a bit to get it to work.

Do you have the means to acquire the sensor??.....That'll be a lot less expensive......If you are getting signal then it may go to an IC that may not be economical to repair....Replace the sensor 1st if in doubt....

[jonny78]

Re: le32c530f1

dam, how could anyone turn a profit when you have to spend coin like that to get a tv up and running?

"The page you requested cannot be found"

[jonny78]

Re: le32c530f1

The above ebay link says BN96-13451B = BN96-13022B = BN41-01382A Control panel Samsung Function Board

http://www.lcd-plasma-parts.co.uk/<b...XU-BUTTON-UNIT

£3.99 + VAT

Thanks..link doesnt work but found a few similar cheap ones but out of stock! ebay all want ridicolous amounts!!!

[dick_barton]

Re: le32c530f1

Just double checked the link but just noticed that they are out of stock which I hadn't noticed first time.

[dskall]

Re: le32c530f1

Probe your ir sensor pins while you press remote one should drop voltage. I would think most ir sensors out of different models will work.