The red standby LED turns on solid when I plug the unit
in, but when I hit the power button, the LED slowly
gets dimmer, and then slowly gets brighter, and then
repeats this undulation.
I cannot turn the undulation off with the power button: I
must unplug the unit and plug it back in, to get the solid
red LED again. Nothing shows up on the screen at any
time.
All voltages on the power supply seem normal: 3.5V, 12V,
and 20V. But I don't know of a way to check if the high
voltage going to the CCFLs is turning on or not.
I was thinking this is likely a main motherboard issue, but
it seems possible the high voltage going to the CCFLs
is the problem.
What do you all think?
in, but when I hit the power button, the LED slowly
gets dimmer, and then slowly gets brighter, and then
repeats this undulation.
I cannot turn the undulation off with the power button: I
must unplug the unit and plug it back in, to get the solid
red LED again. Nothing shows up on the screen at any
time.
All voltages on the power supply seem normal: 3.5V, 12V,
and 20V. But I don't know of a way to check if the high
voltage going to the CCFLs is turning on or not.
I was thinking this is likely a main motherboard issue, but
it seems possible the high voltage going to the CCFLs
is the problem.
What do you all think?
Comment