-
-
Re: Eeprom dump thread!
You Fixed it!!! I downloaded the EEPROM bin like 50 times, with freeze and without, always get the same CHKSUM, so it was heavy corrupted. Attached is a picture of the TV working, all menus work fine and the sound too, ThanksAttached FilesLast edited by luzmina; 02-09-2023, 11:50 AM.Comment
-
-
Re: Eeprom dump thread!
I put the Emmc dump for a SONY XBR-65X810C in the link below, the file uncompressed is 15GB, I do not think I can uploaded in this forum a file of that size. Any question post it in this thread.
https://drive.google.com/file/d/14UL...usp=share_linkComment
-
Re: Eeprom dump thread!
I need help of this,I need a dump of SONY LCD TV MODEL:KLV-32R402A SER.NO.4180751 pleaseComment
-
Re: Eeprom dump thread!
Need a bin dump for my Insignia NS-46l240a13 6MF01001C0 (569MF1101A) which I'm trying to resurrect. It's MX 25L1606L[or L,E,D?]M2I-12G Flash is all FFs. Sorry if it has been posted but I couldn't find the dump using local 'Search'.Last edited by VladC; 03-08-2023, 02:11 AM.Comment
-
Re: Eeprom dump thread!
Need a bin dump for my LG 22lg30-ua chassis la85C, or any for the processor LGE1854c. Old dump not available.Comment
-
Re: Eeprom dump thread!
Hello , will it be possible the firmware for this tv , because someone installed a fake firmware , it does not tune channels in any band, hdmi okAttached FilesComment
-
-
Re: Eeprom dump thread!
Since I could not find a dump for Insignia NS-46l240a13, I upload a dump for Insignia NS-32l240a13 instead. I lifted it from (almost) the same mainboard which I bought to replace. Should work on both models. Hope it'll help somebody.Comment
-
Re: Eeprom dump thread!
hi I need dump software for 17mb120. can be from any brand or panel.Comment
-
Re: Eeprom dump thread!
hi I need dump software for LG49UF853V-ZE (EAX 66165202)
THANKSComment
-
Re: Eeprom dump thread!
Dump what, eeprom, emmc?Comment
-
Re: Eeprom dump thread!
sorry for the omission, i mean it eeprom
I would also like for the model LG 55UF8007-ZA ( eax66165204) (eeprom file)Last edited by g.pol; 03-24-2023, 02:47 PM.Comment
-
Hello, This might be a long shot, but I'm looking for an EEPROM dump for a HP Photosmart C4280 All-in-one printer.
The printer seems to be in cartridge alignment mode. Sometimes it print the alignment page and then hangs during the scanning step, sometimes it hangs during the printing process and sometimes it hangs during the boot process. If I let it idle for a while then it flashes the back-light of the top screen and there's a letter E. Bottom screen is asking me to restart it to no avail. I have to remove the power cable from the printer for a couple of minutes to make it work...02-17-2022, 09:09 PM -
Good day to every one,
I have AVR 171 the IC1504 (24C32) eeprom is corrupted not able to read.
Does anybody have an eeprom dump file? I really appreciate any help.
Thanks in advance.07-01-2024, 09:04 PM -
P14s Gen 2
HT4B0/HP4B0/HT5B1/HT4B2
NM-D352 Rev 1.0
sn PF-35P15W
Requesting thunderbolt dump
also attached is the tbt dump. I extracted the bin from the cap file and modified it, not sure if it's correct. also didnt work.... -
Hi
I was working all day on a 42" with no backlight = Driver is bad . LED Tester. Image exists
As I was reassembling, I discovered faults on the screen ( used the LED Tester to power the strips).
Right distribution board, 2 Flexs, near them:
The one near the center has 1" line on screen. Pressing on the board-side or Panel side of the Flex bonding place results in some change, I sensed heating one time, but main fault line remains
The other, pressing on the Panel to the Chassey and the lines disappears 99.99%
I... -
Comment