Re: Lg 50" plasma no picture but sound
Its open
Its open
-
-
Re: Lg 50" plasma no picture but sound
Im getting 001.0 om 200MComment
-
Re: Lg 50" plasma no picture but sound
Ok im getting 001.0 on 200M rangeComment
-
Re: Lg 50" plasma no picture but sound
Different from the usual failures.
I've had 4 of these models and that cap usually falls short causing all sorts problems.
Change it out anyway, use a 22nf cap. You should get a reading across it in circuit.Comment
-
Re: Lg 50" plasma no picture but sound
It looks like it could be cracked tbhComment
-
Re: Lg 50" plasma no picture but sound
Sorry just read the above,
Put your meter in a lower ohms setting.Comment
-
Re: Lg 50" plasma no picture but sound
If it's shorted it's bad, and needs changed out.Comment
-
Re: Lg 50" plasma no picture but sound
How do i know what size they are theres no rating on them would need to pinch one from a spare boardComment
-
Re: Lg 50" plasma no picture but sound
If i go lower i get no reading but the cap looks to be blown or crackedComment
-
Re: Lg 50" plasma no picture but sound
There's no schematic forysus boards.
Use a 22nfComment
-
Re: Lg 50" plasma no picture but sound
I dnt have caps tht small but i could take one from another board but how do i know the rating of them to get a 22nf?Comment
-
Re: Lg 50" plasma no picture but sound
Have you got a multi meter that checks capacitors? or a esr/capacitor meter if not you may have to purchase some capacitors of that value.Comment
-
Re: Lg 50" plasma no picture but sound
My meter does capacitance but ive not got the connectors for itComment
-
Re: Lg 50" plasma no picture but sound
Ok so ive changed it and i now have 17.7 volts which is good also have green flashing light nowComment
-
Re: Lg 50" plasma no picture but sound
Amazing what 1 little cap doesAttached FilesComment
-
-
Re: Lg 50" plasma no picture but sound
Thank u so much very much appreciated for your time and knowlegeComment
-
Re: Lg 50" plasma no picture but sound
Hamie, How in the world did you find that capacitor had gone bad? Wow.
Model number wasn't mentioned, but searching the zsus mentioned I see it might be LG model 50pb5600 or 50pb660v?
Still, wow. good catch.Comment
-
Re: Lg 50" plasma no picture but sound
Hello Hamie
I have here a LG Plasma 50PB5600, and there is a green flashing led on the control board, i have 18 volt on YSUS, all voltages are good.
It flash: 1x long, 1x short, 1x long and 1x short, and this repeats.
What means this?Comment
-
Re: Lg 50" plasma no picture but sound
LG Plasmas seem to have a lot of issues...I'm dealing with something similar with my dad's set. I'll post in a new threadComment
-
Picked up a bahemoth plasma TV not too long ago and just now getting around to looking at it.
No picture but you hear the TV static (white noise) playing loud and clear.
The back was already taken off (and no screws were provided) as the previous owner had already taken a look.
But it seems they didn't get too far and just left it.
When I first took a look I was amazed at how pristine the inside looked.
Its as if the TV had been in a time capsule.
Caps looked like they were just pulled off the self.
Copper coils had no sign of corrosion on... -
Hi, I have a Samsung UE50TU with:
- sound and backlight, but no picture
- when it arrived, it had a picture for a few seconds
- it keeps rebooting
- without ribbon cable between the two panel boards, it does not reboot but I have no picture
- without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
- when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.
- without cable between mainboard and lcd panel and with a jumpered... -
I have a 60 inch Samsung UN60EH6000F flatscreen TV. The screen went black a few months ago Sound is good, backlight is good, no menu. I replaced the TCon board with a used board purchased from Ebay. It worked fine for a 3-4 months, then the screen started ‘fading' back. Once again, sound is good, backlight is good, no menu. However, this time the picture looks fine for about 10-15 minutes, then fades back. If I power cycle the TV, the display reappears, for another 10-15 minutes, then fades black again. Repeatable ever time.
I ordered a supposedly ‘new' Tcon board this time, and... -
Hello everyone,
Ive got a UE60KU6079 on the workbench that is giving me some headaches trying to troubleshoot.
The previous owner stated that there had been white dots on the screen which from the description sounded like some lenses fell of the backlight LEDs.
He had opened the TV from the back, trying to get to the backlight, supposedly gave up, reassebled everything and gave the TV to me.
I expected the worst like ripped COF cables or a cracked panel but could not find anything like that yet.
Anyway I still fully expect that there has been something seriously damaged... -
Hi all
I was just given a Samsung TV with the issue. I read various threads and videos and attempted the ribbon tape method to gain an image, but no luck.
Symptom:
No picture no sound.
When I plug in the power cord, Backlight LED turns on for a half second and then turns off. The red LED next to the power button located center bottom flashes 2 or 3 times. When the power button is pressed after, it does the same thing.
No sound at all.
What I tried:
1. I tried unplugging the left or right ribbon...
Comment