Olevia 255TFHD Intermittent backlight flicker

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • patrickoneal
    New Member
    • Nov 2015
    • 2
    • USA

    #1

    Olevia 255TFHD Intermittent backlight flicker

    I have an Olevia 255TFHD 55" LCD that I purchased in 2008 for a good price after Olevia got themselves in some financial trouble. The initial set I received from Newegg had backlight issues. Within an hour of turning the set on, the backlight would almost turn off and then come back up to full brightness in a split second, sometimes once, sometimes it would do this in rapid succession. When it would light back up, the set made the same high pitched sound that it normally makes when the CCFLs light up when you turn the set on. I exchanged the set for another, and it's been fine until recently. Now within minutes of turning the set on, the backlight will dim and turn back on in a split second. Just like with the initial set, it may do this once, or a couple of times, then all is well. It seems fine after one bout of this behavior, but I think I've seen it happen again during extended viewing.

    I'm not planning on repairing it until it quits altogether, but I'd like to know what to look at first when that happens. Loose connections? Bad CCFL tubes? Bad inverter(s)? I think the set has multiple inverters, and it appears the whole screen dims when it happens, so I don't know if that rules them out. I'm also wondering if the set is just poorly engineered, being that the first one I had in 2008 did the same thing new out of the box.

Related Topics

Collapse

  • C152Heavy
    Samsung LN46C630K1F – Intermittent Backlight, BN44-00341B Power Board
    by C152Heavy
    Samsung LN46C630K1F – Intermittent Backlight, BN44-00341B Power Board

    Summary for TL-DR readers:
    • Backlight is intermittent, may come on with TV boot or not. No flickering, never fails during TV on.
    • Have obtained Samsung schematic & service documents - Can upload if helpful.
    • Have read ALL applicable threads
    • C1818 and CP820 replaced as low hanging fruit
    • CN802 data taken for normal and failed BL operation. SUMMARY: Pin 2 - 5vDet = 3.52 @normal, 0.0 @BL fail. Pin 6 - EPWM = 1.631 @normal, 1.058 @BL fail.
    • VCC pin (18) of PFC...
    01-11-2023, 02:53 PM
  • triplefour
    UN65TU700DF picture and sound but no backlight. BL tests ok but repl. PSU didnt fix!
    by triplefour
    this tv is throwing me for a loop. do samsung tvs no longer have the backlight self test feature built into the power supply?
    i tested the backlight with my LED tester and it lights up both strips. one of them reads 100v and the other reads 63.7v.
    unplugged mainboard from power supply but left backlight plugged in, and then plugged psu wall power in. expected to see backlights light up but see nothing.
    according to how ive diagnosed in the past, this would almost always be a bad power supply. replacement power supply was cheap like 20$ from ebay. but still i get not even...
    09-13-2023, 10:43 PM
  • DanPoka
    Guide me through repairing a Dell p2210f LCD ccfl backlight monitor
    by DanPoka
    I bought this p2210f dell monitor to fix. Schematic is the same as p2210.
    Behaviour is that monitors comes on but then backlight switches off almost instantly. If I look with flashlight I can still find the "No signal message". So definitely a backlight issue. Trying to advance the issue I proved that the protection circuit is switching off the backlight by shorting out C3 and resistor to disable the INL chip then re enable by removing the short.
    This is where it gets interesting. When I disassembled the monitor to solder leads on c3 capacitor I noticed the backlight flickered...
    02-15-2025, 05:05 AM
  • Comp_Pro
    No Backlight Macbook A1990 820-01041
    by Comp_Pro
    Hello all,

    Am trying to figure out this backlight issue with this A1990 Macbook Pro.

    Tests performed:

    There is no backlight even with a good screen.
    Backlight IC is receiving the correct support voltages.
    Fuse F8400 ok
    Current sense resistor R8400 ok
    Backlight IC is receiving 3.3V on enable pin.
    Backlight IC receiving voltage from PPBUS_G3H, aprox 12.5V.
    Backlight IC receiving 5V from PP5V_G3S
    Backlight IC BKLT_SCL and BKLT_SDA both measure 0.545V diode mode to ground
    I2C_BKLT_SCL and I2C_BKLT_SDA both measure...
    05-06-2024, 10:23 PM
  • Zippo978
    Telefunken te43550b40q2k intermittent backlight
    by Zippo978
    Good morning everyone

    I have this Telefunken te43550b40q2k TV that has intermittent backlighting, sometimes it turns on and then does not turn back on.

    I tested the LED bars and all three work, not even one burned LED, then I tried to put only two bars short-circuiting the end of the connection cable and it does not give any problem the LEDs stay on without problems, I also tried short-circuiting the central connector and the initial one, always no problem, but as soon as I put the third bar, no matter the position the problems start again.

    Thanks in advance...
    09-04-2024, 01:35 AM
  • Loading...
  • No more items.
Working...