panasonic tx-p50c3b 7 blinks wont turn on

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • wreksta
    Badcaps Veteran
    • Aug 2013
    • 508
    • england
    #1

    panasonic tx-p50c3b 7 blinks wont turn on

    hi all I got. panasonic tx-50pc3b
    it wont switch on and has 7 blinks
    ive tried finding a short on the ss and sn boards
    but cant find one

    any ideas to determin the fault
    ie tests to carry out to find this fault
    Tags: None
    • wreksta
      Badcaps Veteran
      • Aug 2013
      • 508
      • england
      #2
      Re: panasonic tx-p50c3b 7 blinks wont turn on

      any ideas

        Comment

        • Moreno83
          Badcaps Legend
          • Jun 2014
          • 2008
          • The Netherlands
          #3
          Re: panasonic tx-p50c3b 7 blinks wont turn on

          Could you post some clear pictures of the tv? ( backside ).
          I only repair Panasonic plasma tv's! Currently owning a TX-P55VT50 and still searching for a ZT60!

            Comment

            Previous template Next

            Related Topics

            Collapse
            • Andre Gilbert
              Panasonic TC-P55ST50 8 blinks then no blinks
              by Andre Gilbert
              Hello! yes I know there is already lots of information about this issue. I have a Panasonic TC-P55ST50 that originally displayed an 8-blink error code. Following the troubleshooting flowchart, I ended up replacing the SS board. However, even after replacing it, the issue persists. The TV turns on and stays on without displaying an image, and continuity is confirmed on all connectors. What am I missing hereπŸ€”?
              Ok Im a mechanical engineer ...but I thought I was able to follow a rather simple flowchart for electric troubleshooting πŸ˜‚.

              TV Model: Panasonic TC-P55ST50
              ...
              1 Photo
              11-20-2024, 08:52 PM
            • Rictech
              Panasonic SA-MAX770PU SMPSU board fault....
              by Rictech
              Hello everyone. πŸ˜€

              As per thread title, this unit has a serious SMPSU fault. It blows F1001, which is a 10A M205 in the phase from the mains input.
              Very first thing I tried, was simply replacing the fuse, but the replacement ceramic fuse blew immediately.

              Looking at the schematic for this PSU, I then removed what I thought was the next likely candidate: D1001 - the HV main bridge rectifier.
              This isolated the fault(no longer blows the main fuse), but does not point me to the actual fault.
              There are no devices that have exploded or otherwise show signs...
              08-26-2024, 01:05 AM
            • jm1234
              Panasonic plasma TX-P42ST50 - 6 blinks
              by jm1234
              Hi,
              anyone able to provide the service manual for old plasma Panasonic TX-P42ST50E?
              It turns off almost immediately (0~5 seconds after pressing the on/off button) and starts flashing the red diode 6 times.
              I disconnected the left-hand side board (SC?, both the ribbon cable and the power cable to it) and also another ribbon going to bottom left board. Then the led signal is 8 flashes. According to service guide to another Panasonic plasma it would mean the left-hand side board is faulty. But I'm not sure it 100% applies to my model.
              I checked that board for any obvious faults...
              05-22-2024, 06:59 AM
            • pajdek
              Lenovo Y700-17ISK turn on and off
              by pajdek
              Hello, i have some issues with my laptop Lenovo Y700-17ISK (motherboard BY511 NM-A541), it started when i turn on the laptop, but the lcd wont turn on, i then connected it via hdmi to tv and screen was ok. So i thought maybe lcd stripe is faulty, i removed the bottom cover, disconnected main battery, reset the cmos by disconnecting battery for 1 min, then slighty move the lcd stripe. Conncted power supply and tuned on my laptop, the lcd turn on, it started to load os, then it turn off, after a second it turn on, then after like 3 seconds turn off again, and so on. Removed power supply, waited...
              09-20-2023, 02:49 AM
            • Alicat
              Panasonic Plasma TH-50PZ85U No screen No blinks on red power light
              by Alicat
              Hello,

              Stopped by this site trying to fix my parents Panasonic Plasma TV.

              Model number is TH-50PZ85U

              Power comes on and the red power light stays on solid.

              Did a few checks like hold the power button on for 60 seconds, hold the - Volume while holding the menu button, no luck, still@ blank grey screen as the screen lights up very vague.

              I also hear a few clicks.

              I also think my parents said there was a thunderstorm and the TV failed after that.

              Section 6 in the service manual talks about power and no screen,...
              10-30-2024, 10:09 AM
            • Loading...
            • No more items.
            Working...