Re: LG 37lc55 turns on few minutes later screen goes out
Damn not good anyway to be 100% sure its panel failure? Would explain why even with new main board the problem persisted
LG 37lc55 turns on few minutes later screen goes out
Collapse
X
-
Re: LG 37lc55 turns on few minutes later screen goes out
Hmm strange wander what lg did there anyway. The panel is a AUO (junk) think its the same panel used in the one I have which is failed I will let you know on Monday if it is I would say panel failure.Leave a comment:
-
-
Re: LG 37lc55 turns on few minutes later screen goes out
Just reading this now are you sure this is a 37lc55 because I have one in atm which is a completely different chassis ? Also the one I have is a panel fault what panel does yours use ?Leave a comment:
-
-
-
Re: LG 37lc55 turns on few minutes later screen goes out
I'll check the MOSFETs on psu I had a new main board off eBay but same problem persisted unfortunately not sure if it was dodgy board or psu. Will upload photo in morningLeave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
check the smd caps next to the voltage reg on the main board. and the smd mosfets on the rear of psu
post pics of main board,Leave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
https://youtu.be/oYF9F5ILzVg this is what happens when the TV is turned on, any ideas?Leave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
Anyone have a layout for this board as can't seem to find one to know which capacitors to changeLeave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
Not problem will revert them backLeave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
You used different uF capacitors? uF must "always" be the same , higher voltage is ok.Leave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
Yeah brand new tcon I'm stumped unless main board I bought was dodgyLeave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
Unplug LVDS cable . these voltages are stable?.
With LVDS cable plug in , feel the ics of Tcon with finger , Any hot?
If you already changed tcon . Forget this idea.Last edited by hienton2; 07-17-2015, 05:29 PM.Leave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
Thanking voltages of pins they seem to fluctuate a little
12v = 12.2-12.4
3-4v = 3.2-3.7
6v = 6.1-6.5
19v = 18.5
19v =18.3-18.7
These are the same when TV is working as to when its on blackLeave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
Replaced the main board inside the TV but still the picture slowly brakes up then goes to black any ideas?Leave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
I took all voltage from the pins and they're all out by around 2volts higher then stated on the board also found few diodes and resisters that aren't working so going to swap them out and see where it gets meLeave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
I've decided to come back and sort this I'm testing main board first ex38425201\13 resistors on r100 is coming back shorted or open not sure on term what else should I check?Leave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
Do know if this is important but I replaced some of the caps with night uf ratings but same voltage would this cause problems?Leave a comment:
-
Re: LG 37lc55 turns on few minutes later screen goes out
Any advice guys?Leave a comment:
Related Topics
Collapse
-
by smic717394Hi,
I have a iphone XS that came in for a screen replacement, the screen was badly cracked, and inside missing scues, on the back of the screen still the blue protector, the screen was a LCD. So we replaced the screen and all good, installed the screen and we noticed that pressing the screen with a bit of force but not excessive, the phone dies. After plugging the charger it turns back on, but again if you press it it dies. I open the phone again, and I can't see anything major, with the phone open, if I press on the logic board, battery, charging board, or even putting pressure on... -
by Rav_tangleHi all , thanks for having me & I think this has been asked before but my case seems a bit odd.
I have a MacBook Pro , board 820-2915a and it turns on , chimes etc etc , keyboard lights up, fans spins , can turn caps lock on/off but screen is dead.
Iv tried the resets , shine torch through back logo , nothing , it seems the screen has no power. If I plug charger , it charges but if I disconnect battery it displays green light but won't turn on. Iv tried screen on with another board & it works & seems I'm not getting any voltage at pin 2 , next to ground pin .
is this... -
by reformattJust had a customer bring in a M2 MBA A2681 that had had a screen replacement in April at another repairer. Since then, she has been getting intermittent kernel panics. It's an aftermarket screen, and of course it fails in diagnostics as the calibration hasn't been done. The error in the panic log is "No device added after powering on the rails".
It seems the original repairer has swapped the board and the screen to other MAC's, and said that it isn't a screen issue. From what I understand, by doing a quick search on Google, this is in fact a screen issue. The panic relates...07-31-2025, 08:37 PM -
by krigehi all i was wondering if you could help me troubleshoot this laptop. i bought the motherboard off eBay. it is used. i fitted the motherboard into the housing of the gaming casing and turned it on. nothing shows up on the screen. i checked the connectors and no missing connectors. i also removed the graphics card and nothing on the screen. i even reflashed the bios but still nothing on the screen. can it be a corrupt bios? i even used the HDMI port but it also shows nothing on screen. could this be broken screen or a dead ec chip?...
-
by Ryan.manHello everybody! Posting this in hopes somebody has some expertise that leads to a clear path of troubleshooting that saves me a lot of time!
My macbook has the flex cable problem, the one that prevents the screen turning on. Ive been dealing with this for the last 3 years. Last year it went dead and I managed to fix it following youtube tutorials. But my fix wasnt the best, the problem returned a month later. This week, it went dead again. I again tried to fix it.
This time the original cable broke too close to the screen, it can't be fixed without tearing the screen... - Loading...
- No more items.
Leave a comment: