Samsung 50" Plasma, Model# HP-S5053, Audio, but no Picture

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Nick's Tvs
    Badcaps Veteran
    • Jan 2014
    • 621
    • USA

    #21
    Re: Samsung 50" Plasma, Model# HP-S5053, Audio, but no Picture

    I don't know if its against Badcaps forum policy but if you want I could check the board for you and try and fix it as well. My TV has a vertical line going through it, so more than likely I will try starting a repair service for this board since they are extremely difficult to find.
    I also have a few spare parts from ordering for the last board.
    But yes I will be checking the voltages at each pin of those 2 connectors and let you know what I get. I have closed the shop for the day already, so I will have to do this tomorrow.
    Also if it is against forum policy to post anything about repairing a board for someone please let me know and I can delete this post ASAP

    Comment

    • Vandy30
      Member
      • Sep 2013
      • 27
      • USA

      #22
      Re: Samsung 50" Plasma, Model# HP-S5053, Audio, but no Picture

      Any updates on this?

      I'm also not sure if that is against policy or not. I will talk to the owner of the tv to see how/if he wants to proceed. I figure he may just want to cut his losses. I'm a little discouraged as this is the first time the TV has won, was able to fix 3 up to this point at the component level, but this TV has me stumped. I still have a feeling it isn't putting out the correct voltage and there is something up with the Vsc_h as it is jumping around all over the place and the Vsc_h sub-assy board is making some strange ticking noises.

      Comment

      • Nick's Tvs
        Badcaps Veteran
        • Jan 2014
        • 621
        • USA

        #23
        Re: Samsung 50" Plasma, Model# HP-S5053, Audio, but no Picture

        Vandy,

        I get 100 volts on 90 percent of the connector and then there are 2 I think sending out 24 volts. The top one has the bottom lines being 24 and the bottom connector has the top lines being 24 volt. The rest is all at 100v dc

        Comment

        • dougmore
          New Member
          • Aug 2013
          • 1
          • Canada

          #24
          Re: Samsung 50" Plasma, Model# HP-S5053, Audio, but no Picture

          Hi Vanady30, I too have the same model Samsung HPS5053 with the no pic good sound issue. I just fixed mine with the replacement of one Trans. Q5006. At first I just clipped off the two legs of the chip to test and it powered up first time.

          Figured you would like to know that maybe that is all you might need as well. CHEERS.

          Comment

          Related Topics

          Collapse

          • Document Archive
            Samsung Galaxy Book 2 Notebook Specification for Upgrade or Repair
            by Document Archive
            This specification for the Samsung Galaxy Book 2 Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Galaxy Book 2 boardview and Galaxy Book 2 schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification, datasheet, or download...
            09-07-2024, 05:50 AM
          • TR103
            Samsung TV model UE50TU: rebooting, backlight, sound, but no picture
            by TR103
            Hi, I have a Samsung UE50TU with:
            - sound and backlight, but no picture
            - when it arrived, it had a picture for a few seconds
            - it keeps rebooting
            - without ribbon cable between the two panel boards, it does not reboot but I have no picture
            - without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
            - when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.

            - without cable between mainboard and lcd panel and with a jumpered...
            01-22-2025, 04:12 PM
          • JJAAMM
            SAMSUNG UN55KS9000F picture fades then distorts into vertical lines after 20 seconds
            by JJAAMM
            This was my main TV for the last 6 years. I'm not inclined to throw out a $2600 TV so quickly so I'm trying to investigate the issue.

            Problem
            TV was disconnected from power for 6 months during construction. When I plugged it yesterday picture was fine, after 30 seconds it dimmed then started developing horizontal lines, picture then starts to ghost vertically until it degrades into vertical streaks. TV always displays a perfect picture when cold. I can unplug TV for 5 minutes and plug it back in and picture is restored for 20 seconds. I can also keep it in standby mode...
            07-06-2023, 06:01 AM
          • Mgiffune
            Samsung UN60EH6000F Black Screen, Backlight and Sound Good. Power Cycle Returns Picture
            by Mgiffune
            I have a 60 inch Samsung UN60EH6000F flatscreen TV. The screen went black a few months ago Sound is good, backlight is good, no menu. I replaced the TCon board with a used board purchased from Ebay. It worked fine for a 3-4 months, then the screen started ‘fading' back. Once again, sound is good, backlight is good, no menu. However, this time the picture looks fine for about 10-15 minutes, then fades back. If I power cycle the TV, the display reappears, for another 10-15 minutes, then fades black again. Repeatable ever time.

            I ordered a supposedly ‘new' Tcon board this time, and
            ...
            06-09-2024, 10:28 AM
          • Dodgethis
            Samsung QN75Q6DRA, No Picture, Has BL, and Sound
            by Dodgethis
            Hello all,

            This is my first post, but long term lurker on the form learning as much as possible about these TV's. I was given this TV as due to a power outage of constant On/off of power to TV. The TV originally would just click on and off (Typical Reboot Cycle). I opened the back of the TV, and troubleshooted by taking the 96 pin LVDS off one at a time to see if I had a picture on either side. I finally fixed the reboot cycle by finding the error on the left side of the screen off connector CN 1301, and the TV would stay on. Further troubleshooting led me to the driver boards where...
            09-11-2024, 07:39 AM
          • Loading...
          • No more items.
          Working...