hi all
I finally managed to fix this Panasonic plasma , in the end A board was shorted and keep burning PSU, after two 2 PSS boards and one A board, i managed to start TV.
before I connected new A board and PSS Board , I checked also SN board and C1 and C2 boards, i disconnected all ribbons, after visual check I connected back, tv started normal, I had few horizontal black lines but I reseated all ribbons cables and black lines are gone but something else is there - two thick (brighter than rest of screen) horizontal lines on top and on the bottom, please see picture attached.
anyone knows what's going on, is there setting to be changed in service mode after changing A board ???
I finally managed to fix this Panasonic plasma , in the end A board was shorted and keep burning PSU, after two 2 PSS boards and one A board, i managed to start TV.
before I connected new A board and PSS Board , I checked also SN board and C1 and C2 boards, i disconnected all ribbons, after visual check I connected back, tv started normal, I had few horizontal black lines but I reseated all ribbons cables and black lines are gone but something else is there - two thick (brighter than rest of screen) horizontal lines on top and on the bottom, please see picture attached.
anyone knows what's going on, is there setting to be changed in service mode after changing A board ???
Comment