PSU (LCA90886) standby voltage only. Main board ( LCA10896) does return switch on voltage of 3.3v for a few seconds before before PSU clicing back off. Blue LED then flashing blink code 9 short 9 long. This code is described in manual as " low bias line short protection" but no help as to what might cause this fault. Anyone had any experience as what could be the cause of this error?
-
I have a "HP Pavilion x360 - 14-ba104na" in for repair. The caps lock flash 3 long and 5 short.
HP says this error means:
The red light blinks three times, and then five, short white light blinks (3 long red, 5 short white)
This condition indicates that the computer does not detect the processor (CPU).
Does this mean the CPU is dead or is there another cause for this fault? -
I recently got my hands on a 60" Panasonic P60ZT60 plasma tv (european model) that has some strange issues along with an 8 blink code.
It know this tv is getting old but it was once considered one of the best plasmas ever made, and i think it is still holds on to that even by todays standards.
So, long story short. When i first got the tv it had a very bright washed out picture with very raised blacks in all picture modes and i couldn't find the cause in the picture setting menus.
After doing a factory reset this problem was gone and the picture was back to...01-06-2025, 06:02 AM -
Hello all, I have been here from time to time and now I'm back for some assistance.
So I have the TV above and its doing the one long and one short "V" blinking. I did the reset on the controls on the side of the TV and while holding down the volume - and the input button, then plugging in the TV the "V" light is solid, then very briefly I see the backlight flash, then the "V" goes back to the 1 long and 1 short blinking. I just want to make sure its the backlights before I get the parts to fix it. Is there anything else I can do to confirm its the lights.... -
rev-1.0
input short remove then caps lock 5 long 3 short no output how to solve this problem -
Hello friends.
hp 15 -da009nk ...la-g07cp.
got this lap with capslock 5 long 3 short.
Try new dump f.48 still the same.
try another dump f.04 power on..no display..consumption 0.498..no caps lock blinking.
all voltage are présent.
pl301/302= 3 and 5 volt.
pl1001 1.082v.
pla1 1.033v
plz1 vcc core 1.058v
plg1 0v..i think it s the Intel grpahic
plw1 1.373v.
plv 3/plv4 vga core 0.918v
consumption 0.498.
original bios version f.02..
any help!...