Samsung TV mu6179 with Mainboard BN41-02568B wont save configuration.

[fixitforfree]

IC1603 (SPI Flash W25Q80) contains the T-CON firmware (all data and settings of your panel), rearranging that resistor will not give you anything.

Does this number match the number on your panel tag?

Yes, indeed!

nomoresonys: I was not sure which way would be best. After lotas pointed out why moving IC1603 would be a solution I will try replacing it.

I guess there is no other way to flash that IC with different T-CON data (e.g. via USB stick)? I have done so before with a philips tv.

And lotas: I agree with your observation. Board A does not show any signs of burnt components and the whole TV is quite dirty and might have been in a kitchen with smokers.

[lotas]

And also for different panel models (manufacturers) on the motherboard in the T-CON area there are positional resistors, jumpers and they also need to be rearranged, as on the original board, put both boards in front of you and compare all the places and set them as they were on the original, here is an example that I noticed...

[lotas]

Here's more...

[Diah]

in short words, forget to use boards B, or change any parts. on Boards A, just freezing the answer to repair fault sectors on chips,

[nomoresonys]

in short words, forget to use boards B, or change any parts. on Boards A, just freezing the answer to repair fault sectors on chips,

Well that would sure be a lot easier if it works.