Panasonic TX-P42G15

Collapse
X
Collapse
 
  • Page of 3
  • Time
  • Show
Clear All
new posts
Previous 1 2 3 template Next
  • alltvrepairs
    Badcaps Veteran
    • Jan 2014
    • 219
    • Malta
    #41
    Re: Panasonic TX-P42G15

    Hi,

    I need to know the part number of D865. It has 88 8A markings for TNBA4829 SC BOARD pls.
    thanks
    Attached Files

      Comment

      • alltvrepairs
        Badcaps Veteran
        • Jan 2014
        • 219
        • Malta
        #42
        Re: Panasonic TX-P42G15

        Ok So D865 is RF101L4S
        Datasheet :

          Comment

          • digant73
            New Member
            • Nov 2022
            • 1
            • Italy
            #43
            Re: Panasonic TX-P42G15

            hi,
            I have also an SC board 4782 (AF) on my Panasonic TX-P50V10E with 7 blink.
            As many other users I already identified some bad Q. Just a question on how to test IC and PC in board (without the need to de-solder them). What should I measure? i.e. resistance from VCC/VIN/VOUT pins to GND pin or also between different pins in the chip (i.e. resistance between VIN with VOUT etc...)? For example, what should I measure in the IC561 (buffer) and what values should I read for a good or bad chip?

              Comment

              Previous 1 2 3 template Next

              Related Topics

              Collapse
              • canadaboy25
                Panasonic TH-50PX60U Plasma Shorted Panel Drivers
                by canadaboy25
                Hey guys, I have a Panasonic plasma here with two black rectangles in the display. As you can see from the picture, they affect the menus as well. Both black rectangles extend to exactly the center of the screen.

                I started with the bottom right black bar as it was closest to me on the desk. I found that the two 6.8 ohm resistors pictured were open circuit. I removed them to verify and they were blown. According to the schematic, these are for the 75V VDA rail.

                I then did a diode mode test on the load side of the resistor and sure enough there was a short. I disconnected...
                01-13-2021, 05:54 PM
              • Yanleb
                Panasonic TC-P50S1 shorted TXNSC1EDUU (TNPA4782AB) SC Board
                by Yanleb
                Hi every one. I just want to share the successful repair of my shorted Panasonic TNPA4782AB SC board.

                I don't usually do it but so many parts were shorted that I decided to buy the ShopJimmy repair kit instead of sourcing each components individually. Here is the list of components the kit contained, with a remark indicating if I needed that part or not :

                D608, good
                D618 RF101L4S, good (See warning 1 below)
                D619 RF101L4S, good (See warning 1 below)
                D865 RF101L4S, shorted (See warning 1 below)

                IC464 Inverter HA MC74HC1G14, shorted...
                03-09-2020, 12:00 AM
              • TevasLT
                Dell G3 3779 CPU and GPU vcore shorted
                by TevasLT
                Hello,

                I have water damaged Dell G3 3779.

                Things I did. During visual inspection i noticed PL911 filter was blown up and caps around it PC901, PC902 .. all up to PU901 shorted, found culprit shorted cap on top side of board PC905, removed cap and short up to PU901 is gone. Shorted PJP901 to bypass filter for the moment.

                problem is CPU and GPU vcore coils are all shorted aswell and I don't know where can I safely inject power to test which component or driver is bad.

                PLA01 20.8 Ohm PLI01 3.8 Ohm, PLI02 3.8 Ohm, PLI03 3.8 Ohm, PLI04 3.8 Ohm...
                11-10-2022, 06:55 AM
              • vienzen
                MacBook Air A1466 EMC2925 (820-00165-A) Shorted PP3V3_S0
                by vienzen
                MacBook Air A1466 EMC2925 (820-00165-A) Shorted PP3V3_S0

                1. Problem of macbook is No Display
                2. Found shorted caps on c1212
                3. After removing the shorted caps (c1212) the reading in the c1212 pin1 is .003 in diode mode test, still shorted.
                4. Help me.....
                09-25-2023, 03:05 AM
              • chestercc
                Alienware M18x Shorted CPU Mosfet
                by chestercc
                I've got an old Alienware M18x R1 which shorted out the charger whenever it was connected. Tracked down the short to two shorted caps and burned CPU power controller caused by a shorted mosfet on the CPU's graphic power supply.

                I've replaced the faulty mosfet, two shorted caps and the CPU Power controller (NCP6151S52MNR2G).

                Issue is now whilst there is no short if I attempt to power the system on the fans spin for a couple seconds there are no lights and no further action - the PCH is heating up but there is no CPU power coming out but there is an enable signal...
                07-16-2022, 06:05 AM
              • Loading...
              • No more items.
              Working...