QN75Q6DRAFXZA LCD problem

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • xfox
    Senior Member
    • Feb 2018
    • 84
    • USA
    #1

    QN75Q6DRAFXZA LCD problem

    Hello Badcaps gurus, need some advice with TV, Samsung QN75Q6DRAFXZA, had blinks and restart, starting with one ribbon disconnected (any of two), after some ducktape experiments I got it working, but it has some lines, I'm not a pro, and need some advice.
    Transparent tape - top ribbon (right), blue tape lower ribbon (left)
    Is there any chance to make picture better and where to dig
    Attached Files
    Tags: None
    • Storyteller12
      Badcaps Veteran
      • Jun 2020
      • 624
      • USA
      #2
      Never seen 2 spots that needed to be covered. You can try covering more pins or fewer pins. But honestly this is just a bandaid and not a permanent fix.
      this is the downside to this kind of repair. There’s always going to be some type of loss in the picture quality. Either lines like you have or some type of color loss or both.

      good luck

        Comment

        Previous template Next

        Related Topics

        Collapse
        • howardc64
          A1312 (27” iMac 2009-2011) A1407 (Thunderbolt Display) A1316 (Cinema Display) Display Black Screen Repair
          by howardc64
          Problem

          This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached....
          08-04-2024, 10:36 PM
        • theone111
          Problem with LG Plasma 60PM6700 - Random power downs
          by theone111
          I have an LG Plasma TV 60PM6700 for the past ~12 years.

          In the last ~3-4 months I have been having some issues.
          1. Problem: It started with random picture disappearing (sound still worked).
            Frequency: Happened about once a week.
            Solution: Had to turn off TV wait a few seconds before turning it on again.
          2. Problem: Then it got worse and the TV started to shut down and when turning on the no picture just sound.
            Frequency: Happened about once a week.
            Solution: Had to turn off TV wait about 10-20 seconds and turn it on again to solve.
          3. Problem: TV shuts down
          ...
          1 Photo
          07-22-2024, 10:36 AM
        • Zeonalbasta
          Thinkpad X1 Carbon "LMQ-1MB 12298-2 48.4LY26.021" VCC3M problem
          by Zeonalbasta
          i have a problem with thinkpad X1 carbon gen 2 "LMQ-1MB 12298-2 48.4LY26.021"
          The laptop was turned off because the MOSFET was not transmitting voltage. After checking it turned out that the gate pin on the MOSFET was the problem, because it was producing an inappropriate voltage. and it was discovered that the problem was with the Think engine, so I decided to reprint each pin, and finally the mosfet could work properly. However, there is another problem, even though the voltage has been supplied to the laptop, it still won't turn on, there isn't even an LED indicator. After double...
          09-13-2024, 01:17 PM
        • Tr0ll
          T-con suspect issue. Both ribbon cables no picture. One ribbon cable ok. (58pus8545)
          by Tr0ll
          Hi guys! I realized you have a lot of knowledge here so i am hoping you could point me in right direction with my odd issue.

          The Tv is a Philips 58PUS8545/12, it had no picture but working backlights.

          Original T-con:
          Opened the Tv and tested to unplug one ribbon cable at a time. With this test i could see that i got fine picture on both halves as long as there was only one ribbon cable connected, with two connected picture were gone.

          First replacement T-con:

          I thought it might be t-con and ordered new t-con from china(supposedly tested)...
          10-07-2023, 07:48 PM
        • Gibon378
          Problem with stopping audio and video for no reason
          by Gibon378
          PC Specs:
          • CPU: Ryzen 5 1600
          • GPU: GTX 1080 Palit JetStream
          • MOBO: ASRock ab350 PRO4
          • RAM: Crucial Ballistix Sport 2x8GB 3000MHz (XMP 2.0)
          • PSU: XFX 650W (don't remember what model)
          • OS SSD: ADATA SP920
          • OS: Windows 10 21H2


          Problem description:
          Hi. I have a problem that has been going on for some time (2-3 years). It's hard to explain what it really is. Sometimes, my computer stops playing music, stops videos (starts buffering on youtube), there is no sound in games and when I minimize the game window and return to the game there is a black screen with window borders...
          11-19-2022, 09:41 AM
        • Loading...
        • No more items.
        Working...