Panel or t-con, main would not cause this, panel more likely.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
a lil bit info from expeirence could be the side ribbons if it has them down the left and right of the panel they are little one inch ribbon tabs with little component on
you will have to remove the panel from the tv then the metal frame supports from the front of the panel
i find if i only remove the top and the sides screws the frame will tilt toward you enough to gain access this way also secures the lcd in the frame
drastic you may say but if it has them try pressuring it or slowly peel from panel watch picture if it improves remove whole tab
this has worked for me with a few samsung A models
What??? Do NOT pull the tabs off!!! This kills the panel.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Well, I would be extremely surprised if that didn't leave you with a dead panel. I suspect as this is a 720p AUO panel it uses only left or only right hand gate drivers anyway.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Can you see any points marked VGAMA1 thru VGAMA22 or so? Test the voltage on each.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
The group of test points marked VGAMA1, etc. You will have to find some of the missing ones (need to get all from VGAMA1 thru VGAMA22 or whatever it goes up to.)
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
There's a box around the gamma points. The other two are independent points for other signals.
You also need to find VGAMA3,4,5,9,18,19,20 which are going to be scattered elsewhere around the board.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Hi All i have the same issue on the same tv
but the picture makes everyone look like Dale Winton or Des O'connor
Dark picture all over and has image retention swapped t-con and still the same
Hi All i have the same issue on the same tv
but the picture makes everyone look like Dale Winton or Des O'connor
Dark picture all over and has image retention swapped t-con and still the same
any ideas please
Regards
Gary
Check Gamma Voltages as described above. Chances are you bought a duff T-Con.
Comment