Trying to fix a magnavox 42"plasma power supply. i need 3
1500uf 35w and i have some 1000uf 35w will these work what if i went 2200
Uf 35w. thanks
1500uf 35w and i have some 1000uf 35w will these work what if i went 2200
Uf 35w. thanks
-
-
Re: can i use 1000uf 35w cap in place of 1500uf 35w
No. Not good to change capacitance.
You also cannot use capacitors from RadioShack, Frys, etc. They do not sell low esr capacitors.
Capacitors can be ordered from badcaps.net or Digikey, if you need help ordering, just ask one of us here.Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search. -
Re: can i use 1000uf 35w cap in place of 1500uf 35w
Obviously, I concur with Tom66. The uf is the most important number - don't change it!Comment
-
3COM OfficeConnect Gigabit Switch 16 (3C1671600)
The switch has served me for 10+ years (was new when I bought it). It's a nice switch with connections on the back which makes for quite a clean desk. Reason for taking it apart was that the cooling fan was noisy so I expected it to be dirty/dusty inside and the need to order a new fan. What I found was that it was very dirty/dusty and some electrolytic capacitors which needs attention. There are 3 capacitors which needs to be replaced but the ESR on some of the other ones might be bad as well so I think I'll replace them all. Original... -
Hello Again, so i'm bringing back this Zumax PSU from the gutless thread and going to be doing some modifications, and also putting it into a PC i'm going to throw together out of spare parts to see how long it lasts.
So the first thing i did was fill in the missing filtering, by replacing the cheap common mode choke with a real one and adding a 470nf X2 capacitor in the open capacitor spot, i then replaced the fake Y-class capacitors with real ones, i also swapped out the mismatched primary caps with a pair of Aishi WK 470uf 200v caps, both of which test around 520uf. I also swapped... -
Here is the page of capacitors that I can choose from what is a good choice for a FSP 400-60GLC
https://www.digikey.com/en/products/...Xmc1YPJ6BlESoA
I try to use a 565-1664-ND which is a 10mm in diameter unfortunately it will not fit because there are two of them the same size and value and there is no room and they go to two different circuits not in parallel... -
Hi, my Vizio M60-C3 does not power on. No lights whatsoever. Upon opening up the TV, the power supply board has 4 bulging capacitors. Each is 1000uF 16V. I have read that one can use capacitors of the same uF and higher voltage rating, but is 1000uF 35V capacitor too high of a voltage rating? My local shop only has these higher voltage capacitors so would rather just buy the 35V variety if it is OK to use them.
Any thoughts if OK to use these higher voltage capacitors? -
It's a problem that the screen is not output properly.
There is no problem with the capacitor with the naked eye.
There is no problem when I look at it with the tester.
Is there a place where I can download the graphic card scheme?
Unlike WATER PUMP, it's very complicated.
04-10-2024, 10:44 PM
Comment