While I do not have a manual for this, I believe it's more or less based on a cut-down Samsung PS42B450 or similar. Can we have a photo of the chassis electronics - it may be recognisable.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Can you get pictures? I have a whole board set except buffer and main board for the plasma panel used in that TV. Same as in PS42B450.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
I posted pictures of all the boards except the logic board in the previous post. The logic board is the only one I did not post because I haven't taken anything apart.
Or are you asking if I can get a picture on the TV? If so, I can not get a picture on the TV.
Sorry, I meant can you get bigger pictures -- max 2000x2000 -- will be clearer.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Unplug the power and control connectors (the power connector is grey and the control connector is white.)
NOTE: Do this with power disconnected.
Do you see a picture? It will be very dim and usually purple tinted but it should be there.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Of course with those connectors unplugged, the TV should then be powered on, just don't fiddle with them with power still on. Seems obvious but did you do this?
OK, do you have a digital multimeter?
Check in a dark room for a slight glow from the panel. Also try pressing MENU on the remote to see if any pixels work.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Ok, install all connectors again, with power disconnected. Locate the control board. On it there is a 4 pin connector. The pins will be numbered. Place a jumper - a piece of wire or a HDD configuration jumper works - across 3-4. Remove the LVDS cable -- this is the cable going from the main board to the control board. Power on the TV. Do you see test patterns?
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Comment