Re: sony bravia lcd klv-37s400a restart
You change the red piece inside the box
You change the red piece inside the box
-
I have a Sony Bravia KDL-40V2500 that will not power on. The indicator flashes red 3 times.
I do not hear any sound and I cannot see any backlight.
I have tried disconnecting every cable on each board one at a time to see if anything changes.
The only change is when I disconnect AC-DET cable on the Power Supply board or on the other end if I unplug the CN7009 connection on the B-Board and try to power on the TV the indicator will stay on solid green until I power off.
My friend ordered another used power supply board but it is also doing the red indicator flash 3 times... -
Hello,
i have this sony bravia kdl-43w755c which boot loops. After sony logo, it shows the android animation loading then it restarts…
from what i read online it looks to be an emmc issue…
i’m not familiar with this kind of tv repairs… i’m repairing laptops and gpu’s…
i took out the board and say an samsung 16gb emmc
i don’t have an exact replacement, but i have a few 32 and 64gb emms’s from laptops…
i could try to put one instead of the 16gb one, but will it work?
where do i get the software from?
any help will be much appreciated!...03-06-2024, 12:26 PM -
Sony Bravia 22" LED Full HD TV KLV-22P402B Schematic...10-16-2024, 05:15 AM
-
Greetings everyone.
I also have Sony Bravia, model:
Sony Bravia KD43XF7596BAEP - Android.
What happend is that image dissapeared while we were watching tv.
Diagnostics:
1. TV turns on, no errors
2. Backlight turs on, no errors
3. Power indicator turns on, white color, no errors
4. Menu works on android, you can hear sound while switching channels
5. Volume up and down works via TV remote and via buttons
6. Tunner works, HEVC / MPEG-4 decoder works
7. I get audio from channels
8. No picture is present,... -
Before proceeding with a component level repair, the usual troubleshooting process was followed:
1. Disassemble and unplug everything except the power connector.
2. Replace RAM.
3. Replace CPU.
4. Rewrite BIOS.
Unfortunately the board was still stuck with a 0.75A power consumption at 19V.
After reflowing both GPU and north bridge in one shot (it can't hurt) there was an instant improvement with a constant 1.75A power consumption, but I immediately noticed smoke and the typical smell coming from the GPU area.
I thought to myself "Well,...
Comment