Dynex DX-LCD32, with no power

[budm]

Re: Dynex DX-LCD32, with no power

OK, I need the P/N on the IC as shown in the PDF.

[wfdbackdraft]

Re: Dynex DX-LCD32, with no power

EA1532C
6H1R402
Hn67351

[wfdbackdraft]

Re: Dynex DX-LCD32, with no power

Bump

[wfdbackdraft]

Re: Dynex DX-LCD32, with no power

Still here.

[budm]

Re: Dynex DX-LCD32, with no power

OK, here is the spec sheet of that SMPS IC TEA1532, we need to find out if we have voltage at the VCC pin1, the large cap negative leg will be your ground for your meter black lead.

[wfdbackdraft]

Re: Dynex DX-LCD32, with no power

I just checked it. No power in both stand by and on position.

[kenerly]

Re: Dynex DX-LCD32, with no power

Did you get it fixed, I have one with the same problem.

Thanks

[wfdbackdraft]

Re: Dynex DX-LCD32, with no power

No I never did. It's still sitting in my garage waiting for me to take it to a repair shop when I have some extra money.

[kenerly]

Re: Dynex DX-LCD32, with no power

Any idea the part number and where i can purchase this resister, circled in picture.

Dynex DX-LCD32 TV

Thanks

[budm]

Re: Dynex DX-LCD32, with no power

It looks like 0.1 Ohms. Is it bad?

[kenerly]

Re: Dynex DX-LCD32, with no power

The side of it is blown out and there is black burn marks on the board under it.

[budm]

Re: Dynex DX-LCD32, with no power

That means other component connected to it may have shorted out.

[redtux777]

Re: Dynex DX-LCD32, with no power

Did you ever get this fixed? I have a DX-LCD37 that does similar things. 15 orange blinks

[NMichel0824]

Re: Dynex DX-LCD32, with no power

I have a DX-LCD32 w/o -09 as well, but mine will power on and work, but intermittently turn off and on. Should I take the same route here, or might mine be a little more clear cut? Thank you!

Nick

[Shane711]

Re: Dynex DX-LCD32, with no power

Wow, so I got this TV, would not turn on. Opened it up and the main board was not there. Looking through my parts I do not have one. So then I test the power board and it is dead. Still wondering where the main board is. Looks like I will not fix this, will set aside till I get another. Looking at the screen it does not seem broken but does have some scratches.