GA-RX5LYD REV 1.1 SCHEMATIC AND BOARDVIEW
Hello guys I'm working on AORUS 15P YD laptop. Main issue is the main display is just black but working good on external monitor. Display is brandnew as well. When you hold the power button and let it power on and off for 5 times or more the screen will show up and you can use it normally however, when you shut it down and let it cool down the screen will turn black again. I'm hoping to get a schematic or boardview so I can trace the lines going to the main display. thank you so much in advance. Please drop your ideas.
-
ASUS Zenbook UX36EA
Need UX36EA Main Board schematic and boardview09-27-2025, 10:40 PM -
Looking for x415ma rev2.0.
it is different from rev0.9 and rev3.0
does anyone know or have any clue where i can get documentation of 65=aesy4 chip -
Hello,
I am in search of a schematic or boardview for Lenovo Ideapad Flex 5 14ALC7.
No power and no charging LED with AC Adapter connected. AC Adapter is functioning at 19V, and also tried another Lenovo AC Adapter -- no charging LED still.
There is an active 19V from the USB-C port to the motherboard with AC Adapter connected, so the port is also fine. I am assuming there is a short on one of the power rails, but don't know where to start looking.
Any insight, schematic or boardview would be greatly appreciated.
Model: Lenovo Ideapad Flex 5 14ALC7... -
hello firends
i search the schematic or boardview
I have this motherboard, but I can't find the schematic or the boardview.
The problem is that on the chip marked where 3V should be, there are 5 volts, which indicates that the two are connected.
So the computer doesn't turn on, and the 3V disappears after a few seconds.
The original problem was that when I turned off the computer, the fan stayed on and saw that it was bad since it was directly in the 5V area.
The new problem arose after removing the bad chip.
3V and 5V remained together,...08-19-2025, 08:25 PM -
Can someone submit board view and or schematics for
Asus Zenbook 14 Q425m
Motherboard Part# UX3405MA
Thanks08-13-2024, 04:00 PM
Comment