Looking for the PDF schematic and component placement files for the 820-01523 ( iPhone 11 ), I have a BRD but all the namings are generic so I need a schematic + component-placement image so I can update the information to produce a proper fleshed out boardview
-
YouTube Repair Videos - https://www.youtube.com/user/19PLD73
FlexBV BoardView software - Linux/OSX/Windows - http://pldaniels.com/flexbv
-
Hi everybody,
i am looking for the value of a resistor, that got missing on an iPhone 13 pro.
I attached a picture, where the resistor is marked.
maybe someone of you has a spareboard and can measure the value?
Thank you very much :-)...05-27-2025, 05:34 AM -
Hi there,
i am at the present struggling with an iPhone 13.
Can someone tell me the values of the three caps marked in the picture close to Pin 1?
They are caps or am I wrong?
Photo was taken from a youtube video.
Thank you very much and greetings from Cologne!...06-25-2024, 02:07 PM -
Hello,
I have an iPhone 4S which I don't have the passcode.
I am trying to reset it using iTunes but it cannot even get detected by my computers.
I tried plugging it in a Windows 11 laptop and a Macbook Air M2.
The current shows 5v 1amp when plugged into a charger,
but it stays at 5v 0.1a when plugged into a PC.
I tried in DFU mode and Recovery mode, I get the same results.
Could it be the cable?
Thank you -
Hi ya folks,
Hope everyone's having a good day.
I have a HP ENVY x360 2 in 1 Laptop 13-bf0002TU with nothing on the screen.
The laptop starts but no display. Connecting to an external monitor give me nothing too. Ive attached my original backup bios
Make HP ENVY x360 2 in 1
Model 13-bf0002TU
S/N CND3171C5T
Prod ID 6L2F0PA#ABJ
I looked up at this site before writing this request. And there was a link. But i couldn't download any files from it.
Any moderator could look it up, if possible? It says, "Invalid file... -
hello,
there is an asus gtx1650 which displays fine in windows but if i run a benchmark test it displays artifacts and the driver crashes after a second or two.
I changed pads and thermal paste.
I run mats test but it is reporting 0 errors.
I then tried to run the mods version 400.271_1650 test, it first ran and stopped with a 'breakpoints limit reached after 5 retries' error and the fans went full speed.
After a reboot, I tried to run the test again, but now the test fails and says "ERROR: Couldn't clear GPU's interrupt...02-09-2022, 03:22 PM