Attached Files
-
Silergy SY8310RAC
I just found this on AliExpress: US $2.29 | (2-5piece) 100％ New SY8310RAC SY8310 BCLB0A BCLBPA BC.... QFN-20 Chipset
https://a.aliexpress.com/_mO1oVM7Leave a comment:
-
Hi all, anyone can help me identify this ic, please.
Look like "BCLDNC"
Asus E410KA R2.0 60NB0UA0-MB2100
Leave a comment:
-
Leave a comment:
-
Can anyone help me find datasheet for this ic?
Marking : GCR
Board : IP3_ARN39_M3_V21_20220913AAttached FilesLeave a comment:
-
-
HYCON Tech ,HY4145 .Datasheet --> https://u.dianyuan.com/upload/space/...598-904754.pdfLeave a comment:
-
what ic is this, it measure negative rail of battery while battery resistance to common ground measured .1 ohm on my meter
laptop brand: itel
board number: N140JAL27_MB_V10Attached FilesLeave a comment:
-
-
What about this chip from Oculus Quest 2 controller, can be identify?Attached FilesLeave a comment:
-
-
-
Leave a comment:
-
Hello, help me identify the component.
Marked: ABPHA (SY6288BAAC) ?
manufacturer: SILERGY
Motherboard: NB2686_MB_V5
Thanks.Leave a comment:
-
Please help me finding some infos about this 2 components. One of them SOT25 code R301e, other SOP14 code B1n5KME. TY!Attached FilesLeave a comment:
-
-
Thread started and edited by piernov and SMDFlea. All members are welcome to contribute to the thread, if you have any
pictures, suggestions, spot any mistakes or want new content adding send me a PM or just make a post. Thanks
EDIT: See "IC Marking Codes and Datasheets #2" for more posts. All members please post comments in thread #2.
__________________________________________________ __________________________________________________ ________
Click on the name next to the post # to view the single post... -
Ricoh Power Management IC`s Marking Codes
The attached pdf titled "Ricoh PMIC`s Marking Codes,pdf" was made by me from the main pdf Ricoh_MARKINGS.
....06-06-2021, 12:29 PM -
Hello folks, I seem to have a lot of trouble when it comes to distinguishing markings on SMD components especially when it comes to the question of whether it is a 1 or an I. for example, I see components marked NI. It looks just like that. However, I cannot tell if that "I" might be a number one instead. Is there a rule of thumb that manufacturers use when using these characters? Attached is an example. This is just one example out of many I come across but it's a good illustration of my point. I appreciate any input.... -
im working on HP Probook 450 g5 with no power issue and found out coil beside this ic is short to ground...i remove the ic and short gone....ic code AQP,...looking on this ic marking code but not found https://www.badcaps.net/forum/troubl...and-datasheets...
-
Had someone drop off a laptop in which they were upgrading the ram but forgot to unplug the battery.
Looks like the ram RFI shield shorted a rail going to or coming from a Silergy IC which blasted a component off the board. I'm going to assume it was a cap but really have no way to know for sure since this board schematic doesn't appear to be in the wild yet.
I'm trying to identify the IC model now but it doesn't appear to match any of the Silergy codes from https://www.badcaps.net/forum/troubl...-tablets-and-m...
Leave a comment: