i found the boardview and noticed that n299 which is a capactor at the max77986 battery chip has ground on both sides. Is this normal? what should the voltage be? the device shows 15Volts 0 amps when plugged into a charger
Try our *UPDATED* boardview, bios, & schematic search. Over 2.3 million files for download!
nintendo switch 2 has shorted capactor at max77986
Collapse
X
Related Topics
Collapse
-
Nintendo Switch Endurance HAD-CPU-10 HAD-CPU-01 Schematic & Board view
Switch Endurance HAD-CPU-10 image.pdf
Switch Endurance HAD-CPU-10 PCB layer.pcb
Switch Endurance HAD-CPU-01 image.pdf
Switch Endurance HAD-CPU-10 USB-V2-Mariko-Pinout.pdf
Switch Endurance HAD-CPU-10 PCB layer obdata.zip...-
Channel: Schematics and Boardviews
09-30-2026, 03:30 AM -
-
Nintendo Switch OLED HEG-CPU-01 PCB Schematic & Board view
Switch OLED-HEG-CPU-01 PCB layer.pcb
Switch OLED HEG-CPU-01 image.pdf
Switch OLED-HEG-CPU-01 USB-OLED-PINOUT.pdf
Switch OLED-HEG-CPU-01 PCB layer.zip...-
Channel: Schematics and Boardviews
10-05-2026, 10:50 AM -
-
by TomyleeHi, I’m working on a Nintendo Switch HAC-CPU-20 with no signs of life at all.
The M92T36 and the BQ charging IC have been replaced, with no change.
I found two short circuits:
a capacitor shorted between the DRAM and the M92
a resistor shorted near the BQ chip
I don’t have any schematics, only boardviews without values or component names (everything is labeled Nxxxx).
If anyone has seen this issue before, help would be greatly appreciated.
Thanks 🙏...02-06-2026, 02:49 PM -
Nintendo Switch 2 BEE-01 BEE-CPU-01 Board view and Schematic
List of Switch2 Chips:
NVIDIA GMLX30-A1 applications processor w/ GPU
Micron MT62F768M64D4EK-026 WT:B 6 GB LPDDR5 SDRAM memory
Infineon CP10359AT USB type-C controller
Nintendo B2423 Game Card reader controller
Genesys Logic GL852G quad-port USB 2.0 hub
Analog Devices MAX17050 battery fuel gauge
Diodes Incorporated PI2SSD3212NCE 14-bit 2:1 SSD switch
Texas Instruments TPS2121 dual-input, single-output power multiplexer
Analog Devices MAX18000 boost converter...-
Channel: Schematics and Boardviews
09-30-2026, 03:45 AM -
-
by nikalI need the advice of the more experienced than me.
As the topic says, I have a L480 which suffered a couple of shorted caps after the USB-C (not the one located in the JDOCK). This caused the PD switch to explode and get shorted too. I cleaned the area around the shorted and exploded caps and then removed the shorted and exploded IC as well.
After that I shorted the J13 (by-passing the exploded IC) in order to check if the Laptop boots and the battery charges.
I noticed that the USB-C charger (not the original but a 65W PD compatible charger for smartphones... - Loading...
- No more items.
Comment