rebuild nintendo switch

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • MaC_ToC
    Member
    • Feb 2023
    • 31
    • France

    #1

    rebuild nintendo switch

    Hello,

    I'm taking out my old switch that had a blue screen, I wanted to reball my CPU but I realized that the battery was not charging.

    When I was looking for it I saw that the following capacitors were heating up a lot (in yellow on the picture)

    https://www.badcaps.net/forum/attach...1&d=1677962667

    so I removed them and my battery is charging (I don't know if it has anything to do with it). But when I disconnected the battery from the motherboard I still have a consumption of 0.192A.

    Nothing heats up and nothing seems to be defective

    Do you have any idea where I can get replacement capacitors?
    Attached Files
  • the old man51
    Member
    • Dec 2022
    • 11
    • yorkshire

    #2
    Re: rebuild nintendo switch

    if caps are shorting....the chip is faulty.....also check caps near charging port..if shorted also change chip

    Comment

    • MaC_ToC
      Member
      • Feb 2023
      • 31
      • France

      #3
      Re: rebuild nintendo switch

      Originally posted by the old man51
      if caps are shorting....the chip is faulty.....also check caps near charging port..if shorted also change chip
      Thanks for your answer,

      The fuse at the output of the charging port looks like it is broken.

      Should I change the capacitors or only the chip?

      I'm a bit lost.

      Comment

      • MaC_ToC
        Member
        • Feb 2023
        • 31
        • France

        #4
        Re: rebuild nintendo switch

        But if there is consumption the gun must not be burned ....

        Comment

        • the old man51
          Member
          • Dec 2022
          • 11
          • yorkshire

          #5
          Re: rebuild nintendo switch

          if caps are shorted around chips.......the chip needs changing.......desolder chip and test caps again..to see if short goes away

          Comment

          Related Topics

          Collapse

          • tommy97
            Nintendo Switch Oled - Joy con charging
            by tommy97
            Hi everyone,

            I'm having an issue with a Nintendo Switch OLED that suffered liquid damage. After a full cleanup and replacing the Joy-Con rails and joysticks, everything was working fine for about a week. However, now the Joy-Cons won't charge or connect again.

            I tested with a second set of Joy-Cons, and the issue persists. Measuring the voltage on the connector shows 3.7V instead of 5V, which I believe should be the correct value.

            Any insights or suggestions on what could be causing this?
            03-17-2025, 06:30 AM
          • fab13
            Nintendo Switch lite charging chip heats up and does not short circuit
            by fab13
            Hello everyone


            Small technical problem on a Nintendo Switch lite
            Here's what I noticed: the USB port has been damaged internally, with a short circuit on the power supply line to the small fuse.

            After replacing the USB connector, the short circuit went away and I can't see any other short circuit in the whole motherboard.

            When I charge the console, it seems to be charging: I get 15 volts and an amperage of 0.450 A.

            Then, after a while, the amperage increases to 1.1 A and the BQ24193 charging chip starts to heat up, as evidenced...
            09-16-2023, 04:59 AM
          • nebulink
            Nintendo Switch-No Shorts and not charging
            by nebulink
            This is a strange one for me. I have a Nintendo switch that turned on initially. The BQ chip was getting very hot. I unplugged and tried a different battery in case there was a problem with them one that came with it. I was told that the battery had been swapped.

            After trying a new battery, the unit would not turn on.
            Ammeter shows 15v 0 amp draw.
            Tested around BG, P13 and M92. No shorts. Decided to swap out BG. Same result.
            Checked voltages around BG, M92 and Max 177050.
            Also checked Max 177621.
            Getting desperate, I changed M92. Nothing
            I changed...
            06-23-2024, 03:22 PM
          • Document Archive
            Acer Switch Switch V 10 SW5-017P Hybrid (2-in-1) V 10 Specification for Upgrade or Repair
            by Document Archive
            This specification for the Acer Switch Switch V 10 SW5-017P Hybrid (2-in-1) can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Switch V 10 SW5-017P boardview and Switch V 10 SW5-017P schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification,...
            09-06-2024, 05:30 AM
          • Thomasraud
            Dell Vostro 3550 (v A01 with BQ24707) Plugged in, Not Charging
            by Thomasraud
            Hello,


            i have similar problem as https://www.badcaps.net/forum/showthread.php?t=37828
            QUOTED
            -It works on charger (without battery connected-only charger)
            -It works on battery (without charger connected-only battery)
            -& it also works when plugged in battery & charger, but it's not charging the battery

            //Confirming, i have same issue, but problem started from charger, centre PIN is outputing 10V+ and jumping randomly 19V


            and..


            QUOTE
            The IC cannot maintain the input current level
            ...
            06-28-2022, 06:47 PM
          • Loading...
          • No more items.
          Working...