boardviewer file asus rampage v edition 10

[david azzzzz]

Hi
I'm currently trying to fix my board
Of
asus rampage v edition 10
The problem with the board is post code 00

I'm looking for the motherboard boardviewer file asus rampage v edition 10

I searched for the file without success you only found the file for the motherboard version
asus rampage v extreme
Not compatible with edition 10
These motherboards are completely different in components

I know this because I own 2 motherboards

The PCH works
The 32.768K oscillator
Tested and measured properly
OK.
all the smd caps on the pch is ok all the voltage 1.05v/3.3v ar present.

The BIOS Flashback
Works properly and can be transferred to the board with it
To the 2 bios

The measurements on the motherboard
They all have a voltage of
5 volts and 3.3 volts are present
PCH Volts 1.05 Volts
present.

In terms of resistance
12 volts to the cpu POWER INDUCTOR ok
ground to the cpu POWER INDUCTOR ok
5V OK
to the 3.3V is low.

No voltage of
VCORE
no ram voltage PDDQ CD / AB
Briefly all the voltage
To the CPU area
And DRAM

PDDQ CD
PDDQ AB
PVCORE
no voltage

Almost 0

[anikin73]

Re: boardviewer file asus rampage v edition 10

the first voltage to appear is the ram voltage 1.5V . do check the ram circuit.esp the pwm chip

[david azzzzz]

Re: boardviewer file asus rampage v edition 10

the first voltage to appear is the ram voltage 1.5V . do check the ram circuit.esp the pwm chip

All PWM
voltage
Were measured

PWM DDR AB = 0.129V
PWM CONTROLLER ASP1250-ID4T
IR QFN-40

PWM DDR CD =0.1V
PWM CONTROLLER ASP1250-ID4T
IR QFN-40

PWM VRM
PWM CONTROLLER ASP1257-S08T
IR QFN48
0.053V



CLOCK Gen.9FG1200AK-7LF
IDT MLF-32
no output
I replaced the IC
And the result is unchanged


3 volt power rails
In input
They are all measured at 3 volts
It looks like all the ICs are in standby mode

i check the vccin / p short 10 mosfat out of the circuit its ok
N-MOSFET PH4030DLA SOT669
NXP

All voltages on the capacitors of the
POWER MOSFET SW. IR3555MTRPBF
IR PQFN-32
12V
5V
OK

There is no short on the 12 volt rail
to POWER INDUCTOR

There is no short on
ground to POWER INDUCTOR

All voltage rails
12V
5V
3.3V
1.05V
OK