Hello, I bought a Radeon 5500 XT Dual for very cheap.
The card is not detected by the PC and the GPU remains cold.
Using my fingers, I was able to identify that a linear dropout regulator (uP0132Q) and a small component nearby (maybe a resistor) are getting very hot while the rest of the board is cold.
I get a beep in continuity mode across two caps next to the LDR. Could this be due to a short in the LDR or another nearby commponent? (The caps don't get vey hot)
I'm trying to figure out whether the LDR is faulty or another component aroud the LDR.
If anyone can share a schematic and advise on where the test points are on the board, it would be much appreciated.
The card is not detected by the PC and the GPU remains cold.
Using my fingers, I was able to identify that a linear dropout regulator (uP0132Q) and a small component nearby (maybe a resistor) are getting very hot while the rest of the board is cold.
I get a beep in continuity mode across two caps next to the LDR. Could this be due to a short in the LDR or another nearby commponent? (The caps don't get vey hot)
I'm trying to figure out whether the LDR is faulty or another component aroud the LDR.
If anyone can share a schematic and advise on where the test points are on the board, it would be much appreciated.