Hello, I bought a faulty EVGA GTX 1050 ti. for a very low price. (To use as a graphics card repair / learning project)
The card does not give any display.
I connected it as secondary and ran MATS with the result that both B0 and B1 are indicating 999040 write errrors.
The ony other memory banks are A0 and A1. They don't indicate any errors.
To me it seems strange that both B modules indicate the exact same number of write errors. Could that be a bad solder joint or is the memory controller on the GPU likely to be dead?
Can anyone advise on where to measure the resistance on the board and what the expected values should be?
The card does not give any display.
I connected it as secondary and ran MATS with the result that both B0 and B1 are indicating 999040 write errrors.
The ony other memory banks are A0 and A1. They don't indicate any errors.
To me it seems strange that both B modules indicate the exact same number of write errors. Could that be a bad solder joint or is the memory controller on the GPU likely to be dead?
Can anyone advise on where to measure the resistance on the board and what the expected values should be?