Have two of these, both of them have the same problem: colorful blocks and lines on the output from both ports.
there is no signs of damage or burned components.
The heat sink is massive on this thing and its impossible to measure pretty much anything on the gpu side while the card is running.
the brownish tint is left over flux from re-flowing the solder, as my alcohol in the ultrasound was slightly used ... will clean that up soon
the fets are:
119n03s
79n03s
fet driver
any ideas? could it be the chokes? the fets? should I just place the capacitors? btw are the three red ones 270uF @ 16v?
there is no signs of damage or burned components.
The heat sink is massive on this thing and its impossible to measure pretty much anything on the gpu side while the card is running.
the brownish tint is left over flux from re-flowing the solder, as my alcohol in the ultrasound was slightly used ... will clean that up soon
the fets are:
119n03s
79n03s
fet driver
any ideas? could it be the chokes? the fets? should I just place the capacitors? btw are the three red ones 270uF @ 16v?
Attached Files
Comment