Cisco 2948G-L3 switch

[JEWilson]

Rec's this used in a reported condition where it would lock up
after a an uptime of 3/4 days

I suspect capacitor failure in line with the symptom but
this remains to be seen.

With the cover off, the SMPS PSU is populated with Nichicon
PMs and Rubycon YXGs

The main PCB has four of the devices in the middle with
large heatsinks and there are 4 fans to the rear of the chassis.
The main pcb of the switch has 23 of 10V 1500uF caps
as well as several tant chips caps and a couple of,
what appears to solids at 35V 220uF

My Q is?
The 23 of 10V 1500uF caps are brown with a K mark
on the top of the cap but, the logo on the side is
what appears to be Nc.
The solids have the following markings;
100 220 35z

I do not know what these are. Can somebody help?

I should add there are no signs of distress albeit I
have not tested the ESR of any yet.

Thanks

[willawake]

Re: Cisco 2948G-L3 switch

http://www.niccomp.com/
??

[JEWilson]

Re: Cisco 2948G-L3 switch

Thanks Willa

In actual fact, the solids are 001 220 35z
The lytics are NRSZ series

[kc8adu]

Re: Cisco 2948G-L3 switch

nc caps are ok
likely rebadged sanyo.
i have put nrsz in a ton of stuff with no problem.