Help needed: Full Flash Dump (32MB) for D-Link DGS-1210-28P Rev. F1

[lilos]

Hi everyone,
I accidentally bricked my D-Link DGS-1210-28P Revision F1 while working in U-Boot. I used an incorrect sf erase command and wiped the bootloader section. The console is now completely dead (no output at 115200 baud).
I have desoldered the MX25L25645G (SOP16, 32MB) flash chip and I am using a CH341A programmer to recover it.
Does anyone have a Full Flash Dump (32MB) or at least a working mtd0 (U-Boot) binary for this specific model and hardware revision?
Device Details:

• Model: D-Link DGS-1210-28P
• Hardware Rev: F1
• SoC: Realtek RTL8382M
• Flash: Macronix MX25L25645G (32MB)

Any help or a link to a working .bin file would be greatly appreciated!
Thanks in advance!

[lilos]

This i dump from my broken dgs1210-28p

[Apokrifan]

dump from dgs1210-28p

[lilos]

Thank you. I will program SPI using CH341A and report results.

[lilos]

Hi Guys
I realized that my device is F3 not F1 .
I was following the old dump and now I noticed on the sticker that it is F3, so I need a different dump than the one posted here because on the dump for f1, the device is in a firmware crash loop, any help would be appreciated Thanks

[CapLeaker]

The boot loader is different from a F1 to an F3.

[lilos]

hi I manage to install openwrt on that u-boot fom ver f1 but poe dosnt work, there is no response from controller so maybe becouse the uboot is for f1

[CapLeaker]

Yep, some of the ICs are different. Wouldn’t surprise me that F1 firmware hangs or reboots itself all day long.

[lilos]

Yes Mate if I would have just U-BOOT for F3 it would be great then install openwrt and check poe is working or not