Elo ET1522L - Black screen, back light off, flashing LED

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • TVRepairNoobie
    Senior Member
    • Feb 2015
    • 158
    • USA
    #1

    Elo ET1522L - Black screen, back light off, flashing LED

    Hi Folks,

    I have a few of these monitors with the same symptom. They were used in a call center, monitors are on 24/7.

    My office space is getting smaller and smaller with all these bad monitors surrounding me.

    I did managed to fix one by replacing the big cap 120uf 400v.

    Please HELP!!
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • sam_sam_sam
      Lift Master Garage Door wall switch display / motion sensor controller display disappeared no back light
      by sam_sam_sam
      This happened last Saturday and today I finally had time this morning before I went to work to replace two non brand capacitors

      I will let you be the judge weather or not these are bad or not according to the blue ESR meter that I am using

      I am comparing them to a brand new one that I installed

      The display came back on and the programming was not lost which I was surprised by I would have thought that when the display went blank that so did the memory as well

      I going to let it run for several days before I remount back on the wall next to the...
      09-05-2024, 06:48 PM
    • howardc64
      A1312 (27” iMac 2009-2011) A1407 (Thunderbolt Display) A1316 (Cinema Display) Display Black Screen Repair
      by howardc64
      Problem

      This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached....
      08-04-2024, 10:36 PM
    • learnmore
      Samsung QE55Q60TAUXXU - flashing backlight and flashing standy light--no image
      by learnmore
      Hello Community!

      CASE DETAILS

      Promblem Signs: Backlight on 1 sec off 7sec > repeat && Red standby light: 1blink, off 3 sec, 2 blinks, off 5 secs, 2 blinks, off 3 sec, restart cycle

      13V present on powerboard output. Backlight continues flashing after removing cables to pannel one at a time and even with both disconnected. NOTE: backlight STOPs flashing and remains on when connector between powerboard and mainboard (note Tcon built in) is disconnected.

      Tried inserting firmware on USB and left it in for a few hours, but no change
      ...
      03-03-2024, 09:49 AM
    • PNI E.
      tcl u65x9006 back light on but no picture sounf ok after 40 50 secs
      by PNI E.
      hi guys, i need your help again...i have tcl u65x9006. while i was watching it become darker like when a movie ends, little by little the image disappear. now if i turn on i have back light on, after like 1 min i have also sound but no picuture. the back light is on i take off one at time the ldvs but nothing change always no picture. i tried to cover with a piece of paper the pin of ldvs i cover like 7 8 pins but nothing worked. the tv stay with no picture. there is a tcon board.i checked the voltage there on the fuse i have 11,8 volts. there is caps in shorts on the exit of the tcon i have...
      02-20-2025, 08:36 AM
    • Alicat
      Panasonic Plasma TH-50PZ85U No screen No blinks on red power light
      by Alicat
      Hello,

      Stopped by this site trying to fix my parents Panasonic Plasma TV.

      Model number is TH-50PZ85U

      Power comes on and the red power light stays on solid.

      Did a few checks like hold the power button on for 60 seconds, hold the - Volume while holding the menu button, no luck, still@ blank grey screen as the screen lights up very vague.

      I also hear a few clicks.

      I also think my parents said there was a thunderstorm and the TV failed after that.

      Section 6 in the service manual talks about power and no screen,...
      10-30-2024, 10:09 AM
    • Loading...
    • No more items.
    Working...