ART710A, RCF monitor speaker schematic/advice please

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • zen
    Badcaps Veteran
    • Apr 2011
    • 511

    #1

    ART710A, RCF monitor speaker schematic/advice please

    HI all

    It's yet another monitor speaker.

    Trying to rebuild the audio circuitry.

    The story so far, after removing loads of glue.

    MOS3 & MOS4, both type IRFB4229, S/C

    Also replaced Gate drive chip for them, U7 type IRS20955S, plus U3 which is same chip type for a different set of FETS.

    Anyone have experience working on this model?
    Attached Files
  • zen
    Badcaps Veteran
    • Apr 2011
    • 511

    #2
    Re: ART710A, RCF monitor speaker schematic/advice please

    Require value of R63.

    Measures 2K2 but has been corroded by glue & need to know if it's ok.
    Attached Files

    Comment

    • zen
      Badcaps Veteran
      • Apr 2011
      • 511

      #3
      Re: ART710A, RCF monitor speaker schematic/advice please

      Suspect R63 is correct as there is no real link from it to damaged parts of circuitry.

      Powered speaker by slowly increasing the AV supply using a variac.

      Fully powered, but no audio for around 1 minute, then music from tweeter, but not main driver.

      Shortly after spotted some smoke & hopefully powered off before damage occurred.

      Suspect main driver faulty.

      Tweeter coil measures 5R4

      Drive coil measures 3R3

      Comment

      • zen
        Badcaps Veteran
        • Apr 2011
        • 511

        #4
        Re: ART710A, RCF monitor speaker schematic/advice please

        A previously found corroded resistor that I must have replaced by error with wrong value.

        R62 which is on the VCC line to U7 is where I went wrong.

        Used a 4K7, but when I compared the mirror circuitry for the tweeter drive value is 47K.

        Replaced with correct value & now main driver producing audio, but the main output FETS getting quite hot.
        Attached Files

        Comment

        • zen
          Badcaps Veteran
          • Apr 2011
          • 511

          #5
          Re: ART710A, RCF monitor speaker schematic/advice please

          One of the previously replaced FETS had shorted therefore swapped out both plus U7

          Comment

          • zen
            Badcaps Veteran
            • Apr 2011
            • 511

            #6
            Re: ART710A, RCF monitor speaker schematic/advice please

            MOS 3 seems to be the FET that keep failing, then DC finds its way to the tweeter, which has in turn blown it.Cannot seem to work out why.

            Bass driver amp driver circuitry good.

            Comment

            • amingpx
              Member
              • Apr 2018
              • 27
              • iran

              #7
              Re: ART710A, RCF monitor speaker schematic/advice please

              Hi.
              rcf art 415a protected.
              The green and red lights are on together.* *Gate pin in Mosfets ate not enabled through IRS20955s...There is 12 volts in irs . The. I changed ADAU1701 but problem did not solve.

              Comment

              • zen
                Badcaps Veteran
                • Apr 2011
                • 511

                #8
                Re: ART710A, RCF monitor speaker schematic/advice please

                Hi & thanks very much for your input

                Will update when i have the opportunity to work on it again.

                Comment

                Related Topics

                Collapse

                • Borse2008
                  Seeking Advice: Repairing Dell U3425WE Monitor with Faulty USB-C/Thunderbolt Ports
                  by Borse2008
                  Hi everyone,

                  Looking for some advice or opinions on what to do with a monitor issue I’ve run into. Apologies in advance is this crossovers a few forum categories.

                  I have a Dell U3425WE, which I've recently replaced with another model. That said, the original unit is still fully functional in terms of the display — it works perfectly over HDMI and DisplayPort. However, the USB-C and Thunderbolt 4 ports have stopped functioning correctly. The Issue:
                  • The 90W Thunderbolt 4 port (circled in the photo) no longer charges or powers any device, including laptops or MacBooks.
                  • There’s
                  ...
                  07-15-2025, 04:55 AM
                • atunguyd
                  Acer x163w Monitor PSU schematic
                  by atunguyd
                  Ii wonder if anyone can help me. I have a Acer x163w monitor which is not powering up. The PSU main capacitor's one leg had completly come off - I replaced it but the PSU is still not outputting DC. I found the monitor in questions service manual here on manuals lib but the schematic in there is a completely different - the schematic shows no mosfet to drive the transformer while the one I have does use a mosfet - also the schematic shows only one optocoupler but mine has two.
                  The PSU board is labelled FM-20A02-AAA made by APD as per the image below. I am trying to find a schematic for this...
                  03-05-2025, 02:08 PM
                • momaka
                  HannStar Hanns-G HC194d LCD monitor repair
                  by momaka
                  Normally, I never post repairs this quick after I do them, because… I am usually very slow. But today, I’m making an exception here. Why? No idea. Perhaps only because the repair details are still “fresh” in my head… which is ironic, given this is a 16 year old monitor that hardly anyone will care about today. It is new to me, though. I picked it up last November from someone on my local Craigslist. It wasn’t very close to where I live, but was close to a family friend that I had to go visit anyways. So after watching the posting on Craigslist for a few weeks and seeing it getting...
                  03-15-2023, 10:17 PM
                • doorzon
                  Schematic request for AOC CQ32G1 or CQ27G1 or Q27G2U monitor
                  by doorzon
                  Hi all,

                  does anyone perhaps have a schematic or service manual for an AOC monitor (1440p) of this type:

                  CQ32G1
                  CQ27G1
                  Q27G2U


                  They all seem to use a similar video and power board (it has an external power brick).
                  I've seen various reports of this AOC monitor type that sometimes provides power on logo and display, but most of the time only white back ground.

                  There are no markings for voltages on the boards and regulator part numbers are a bit elusive to determine the output voltage.

                  https://www.badcaps.net...
                  04-21-2024, 03:17 AM
                • zen
                  PE1164T , Compaq CRT monitor schematic / advice please
                  by zen
                  Hi all

                  Customer mentioned the monitor working until he tried to connect a HDMI to VGA adaptor .

                  Now picture pulses , with HT at 52V - 58V...
                  07-07-2022, 09:03 AM
                • Loading...
                • No more items.
                Working...