Hi Everyone,
I'm attempting to troubleshoot my Pioneer Elite Receiver. The standby light comes on when it's plugged in and initially when the Standby/On button is press no relay sounds can be heard. After 30 seconds to over a 1 minute when the Standby/On button is press a relay can be heard, but no power or lights on the display. I've check the fuses and confirmed they are good.
I also attempted to reset the unit by holding down the ADVANCED SURROUND button, press and hold the STANDBY/ON button for about three
seconds.
I've downloaded the service manual (page 9 is the main schematic) and measured IC6001 input 15VDC (approximate) and 5.5VDC (approximate) output voltage.
Any additional advice would be great.
Thanks
I'm attempting to troubleshoot my Pioneer Elite Receiver. The standby light comes on when it's plugged in and initially when the Standby/On button is press no relay sounds can be heard. After 30 seconds to over a 1 minute when the Standby/On button is press a relay can be heard, but no power or lights on the display. I've check the fuses and confirmed they are good.
I also attempted to reset the unit by holding down the ADVANCED SURROUND button, press and hold the STANDBY/ON button for about three
seconds.
I've downloaded the service manual (page 9 is the main schematic) and measured IC6001 input 15VDC (approximate) and 5.5VDC (approximate) output voltage.
Any additional advice would be great.
Thanks
Comment