As you can see in the photo, it is working outside the case but once I reassemble everything inside the case, it is not reading the disk, all zeros on the display !!
The 5-pin black cable is for the tray limit switch and motor.
The 4-pin orange/white cable is for the tracking/focus motors.
The flat ribbon cable is for the laser lens.
I tried wiggling the cables when reassemble and it did nothing !
BTW the display is working fine !
Any ideas ??
Thank you
The 5-pin black cable is for the tray limit switch and motor.
The 4-pin orange/white cable is for the tracking/focus motors.
The flat ribbon cable is for the laser lens.
I tried wiggling the cables when reassemble and it did nothing !
BTW the display is working fine !
Any ideas ??
Thank you