I got this unit from a friend and been trying to fix it. I have made sure it was not in protected mode and as you can see comes on and then off after a certain amount of time. I can not keep it on long enough to check voltages. I would love a schematic and/or some help. I want to try to get it working. I have pulled the transformer and measured ohms across it and get 2.5 ohms. I would expect the transformer to show higher ohms. Any help is appreciated.
I then found this video which states the ohms should be bigger. http://www.youtube.com/watch?v=1xIlqe-P1CM
i did unplug transformer and some of the other leads and found on c1504 5 volts on one leg which i would think it normal and then c1502 i did not find any voltage on any leg ????
Also if you just hit the power button nothing happen at all. No relay click or anything.
Here is the video of what is going on
http://www.youtube.com/watch?v=67GEcKIbqs8
i have the service manual and thinking a bad cap or something as I do not see some voltages.
I then found this video which states the ohms should be bigger. http://www.youtube.com/watch?v=1xIlqe-P1CM
i did unplug transformer and some of the other leads and found on c1504 5 volts on one leg which i would think it normal and then c1502 i did not find any voltage on any leg ????
Also if you just hit the power button nothing happen at all. No relay click or anything.
Here is the video of what is going on
http://www.youtube.com/watch?v=67GEcKIbqs8
i have the service manual and thinking a bad cap or something as I do not see some voltages.
Comment