Toshiba Blu-Ray Player - No Power

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • caphair
    Badcaps Legend
    • Nov 2011
    • 1249

    #21
    Re: Toshiba Blu-Ray Player - No Power

    UPDATE: Replaced the oscillator crystal and player powered up and is working good. Thanks so much for the input about it and the reset circuit!

    Comment

    • stj
      Great Sage 齊天大聖
      • Dec 2009
      • 31003
      • Albion

      #22
      Re: Toshiba Blu-Ray Player - No Power

      good.
      dead clock is not as rare as people think.

      Comment

      • caphair
        Badcaps Legend
        • Nov 2011
        • 1249

        #23
        Re: Toshiba Blu-Ray Player - No Power

        Originally posted by stj
        good.
        dead clock is not as rare as people think.
        Do they always give this same symptom? I have another Sony BluRay player that tries to boot and freezes every single time. Started another thread about it but no real replies

        Comment

        Related Topics

        Collapse

        • GLISIT
          Asus Probook P5440UF-XB74 power issue
          by GLISIT
          Hi all,

          TL;DR - this laptop is driving me nuts with the oddball power-related behaviors. Appreciate any insight you can provide!


          I'm experiencing a power issue on an Asus Probook P5440UF-XB74. Although I've worked with electronics and computers for decades, this is my first attempt at getting into motherboard-level component troubleshooting. Any help the community can provide is greatly appreciated!

          A few weeks ago I was using the laptop (on battery power) for a Zoom meeting. The battery was running very low (long meeting) but I wasn't worried about...
          01-16-2025, 02:29 PM
        • sam_sam_sam
          Desoldering gun station modified to use a 18 volt @ 20 amp switching power supply
          by sam_sam_sam
          I have wanting to do this project for quite sometime now and I finally found a switching power supply that will work on this desoldering gun station ZD-915 that the original switching power supply took a shit and just was not worth trying to fix it because this switching power is not quite big enough to handle the heater element and the vacuum pump

          One note when I tested the switching power supply and the voltage control board I noticed that this desoldering gun heat up much faster than the original switching power supply which I was really surprised by to the point that I might buy...
          03-31-2024, 02:12 PM
        • SkishyIshy
          Sony Bravia XBR-65x900f: No Power, No Standby-light - however 3.3v STBY is present
          by SkishyIshy
          Hey All,

          I have a Sony 65x900f that I purchased cheap because of a no-power issue.
          I assumed that because there is no standby light visible, it would be an easy fix - however upon opening up of the unit I can confirm that the 3v3 standby voltage is making it's way from the power supply to the main board. I'm a little confused as to why there is no standby light.

          I am firstly wondering if anyone has this model of TV, or has worked on one and can give me some insight. I have tried to find a service manual for this model, to no avail - and would really appreciate...
          03-17-2021, 11:44 AM
        • AleMonti
          LG 55EG910V - no power and no standby light
          by AleMonti
          Hi everyone,
          I'm trying to troubleshoot and repair this old LG OLED curved TV, model 55EG910V.
          I did some basic troubleshooting and reviewed most related posts here, but I wasn't able to isolate the issue.

          The TV shut itself off during playback and never came back to life - the standby light remains off. My dad claims that it has happened a few times in the past but the issue resolved itself after some time. Not this one.

          After checking the basics I did the following:
          • I measured all voltages and as expected the only active supply is the 3.5V standby. It
          ...
          11-04-2024, 05:02 PM
        • OMWANA1966
          Toshiba Satellite C850-B888 Standby Power Blinking
          by OMWANA1966
          I have the above toshiba which worked on by another technician with blinking light on the caps lock dvd rom drive and the standby power upon insertion of the charger.

          what i have done

          cleaned the mb

          used hot air

          disassembled the board but the problem is same

          anybody with similar problem which has been solved can assist

          thanks
          04-13-2023, 12:04 AM
        • Loading...
        • No more items.
        Working...