Help with identifying a component

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • hostbridge
    Member
    • Jun 2012
    • 11
    • das

    #1

    Help with identifying a component

    Hello, I have a big problem with an HP computer with the epv51 la-g078p board, above the chip only the letters 8ieaqd appear and in BOARDVIEW it is identified as PU301, this component has shorted out and I am unable to find the replacement or the reference to be able to replace it, can someone help me? Thank you very much.
  • BigDon
    New Member
    • May 2014
    • 5
    • United States

    #2
    Do you have the schematic for the board? Usually the board view files include the schematic in pdf format. If so, look for the part identifier and it will tell you what the part is and the value. From the PU designation, I would guess it’s a pull up resistor on the power-up rail, but that’s only a guess.

    Comment

    • R_J
      Badcaps Legend
      • Jun 2012
      • 9535
      • Canada

      #3
      What are the top markings on the ic? Post a clear picture of the ic
      It might be a SY8286BRAC QFN20 marked AWVxyz
      Last edited by R_J; 10-10-2024, 07:40 PM.

      Comment

      • hostbridge
        Member
        • Jun 2012
        • 11
        • das

        #4
        It is next to the ENE
        Attached Files

        Comment

        • truclacicr
          Badcaps Veteran
          • Apr 2019
          • 299
          • australia

          #5
          Clear as mud.

          What about BIExyz?

          https://comsystem-tlt.ru/files/DS/SY8284BRAC.pdf

          https://ae01.alicdn.com/kf/H4fc8af8bf0e94d75af03d2bc306451217/SY8284BRAC-SY8284-Printing-BIEAQC-BIE-QFN.jpg
          (photo)
          Last edited by truclacicr; 10-11-2024, 01:25 AM.

          Comment

          • hostbridge
            Member
            • Jun 2012
            • 11
            • das

            #6
            It seems so! THANK YOU VERY MUCH

            Comment

            • hostbridge
              Member
              • Jun 2012
              • 11
              • das

              #7
              I'm back to my old ways, after changing the component (SY8286B) sometimes it sends the 3.3v signal through pin 17 and when it feels like it stops feeding the equipment and turns off, can someone tell me what could be happening? The ENE was also changed and everything was reprogrammed, thanks

              Comment

              Related Topics

              Collapse

              Working...