SVI3206D Hybrid IC ( BC POWER MODULE BY SANYO)

[Jeff Pepin]

Re: SVI3206D Hybrid IC ( BC POWER MODULE BY SANYO)

and badcaps.net is the best of internet , i really enjoy this experience since a week soon

[Jeff Pepin]

Re: SVI3206D Hybrid IC ( BC POWER MODULE BY SANYO)

after somes research i can'T finally determine if it can be the case of mosfet or igbt but it look definitively one of them ,, need motivation to takeover this project ,,

did i can only replace the 60 V rail by 12V rail low amp , just to test it without blowing anything ? , i fear this mini mig solder

[budm]

Re: SVI3206D Hybrid IC ( BC POWER MODULE BY SANYO)

Do you still have those silicons that you removed?

[Jeff Pepin]

Re: SVI3206D Hybrid IC ( BC POWER MODULE BY SANYO)

i have 2 of them , with an atmega168 tester sold on ebay the 2 that was not blown resulted that

firt one
second :

both 2 others was blown and not able to test them


i have put this project in standby because im temporary overdosed by theses SVi'S history

ME . SVI
i really sure that on a good road , the P-jfet is probably the P-MOS , and other is probably the N-MOS , i really hate retarded unidentified electronic parts

to be continued , For sure

[Jeff Pepin]

Re: SVI3206D Hybrid IC ( BC POWER MODULE BY SANYO)

i have these again yes

[Jeff Pepin]

Re: SVI3206D Hybrid IC ( BC POWER MODULE BY SANYO)

long time not posted on this topic just to remind i have this amplifier again and again in standby mode , my transistor was a setup of darlington welcome smoke please dont delete this topic i will rework this subject soon '' C'est mon défi ''

[Jeff Pepin]

Re: SVI3206D Hybrid IC ( BC POWER MODULE BY SANYO)

i will make other test with somes mosfet ans i will drop down voltage to make it more compatible with my parts maybe this power module will revive some day

sorry for my poor english im french from quebec

[A-Billi-Tea]

Re: SVI3206D Hybrid IC ( BC POWER MODULE BY SANYO)

I was thinking about this concept recently, it would be excellent to be able to refurbish these STK and SVI IC packages!!!

Can you tell me how you opened the modules? Did you use heat to melt the glue? I have had no success trying so far, but I did get one open by cutting into it with a dremel, but that was a bit messy... :P

[flashgordon22]

Re: SVI3206D Hybrid IC ( BC POWER MODULE BY SANYO)

i usually put a small flat head screwdriver at the bottom corner by the pins and pry up on the plastic that works all the time