Re: Smasung SyncMaster 913N Monitor wouldnot display images
I think buds post says somewhere we need both sides of the board. Anyway the bridge rectifier doesnt look good but it may just be the picture - looks to have heat marks and perhaps a small split? -
With no power to the board locate the 4 joints and meter on ohms 200 test 1 to2 then again with leads reversed then 3 to 4 then again with leads reversed and post result in ohms
When you remove the TOP chip test the solder joints for straight shorts.
Also look up "Dim Bulb Test" for future damage limitation
I think buds post says somewhere we need both sides of the board. Anyway the bridge rectifier doesnt look good but it may just be the picture - looks to have heat marks and perhaps a small split? -
With no power to the board locate the 4 joints and meter on ohms 200 test 1 to2 then again with leads reversed then 3 to 4 then again with leads reversed and post result in ohms
When you remove the TOP chip test the solder joints for straight shorts.
Also look up "Dim Bulb Test" for future damage limitation
Comment