Hi
I've got an ASUS IPIBL-LB (out of an HP/Compaq thing) and there was a high side MOSFET shorted. I did somethings to eliminate it, was on the primary side of the VRM so I started removing the FETs. The first one I've removed was a bingo.
So without it short was gone and Board runs so far.
So question is what to do next?
a) replace the FET (I don't have and I probably have to order it oversees)
b) leave it as is
c) remove the rest of that phase (and what should I remove)
What do you think I should do??
Pictures attached...
I've got an ASUS IPIBL-LB (out of an HP/Compaq thing) and there was a high side MOSFET shorted. I did somethings to eliminate it, was on the primary side of the VRM so I started removing the FETs. The first one I've removed was a bingo.
So without it short was gone and Board runs so far.
So question is what to do next?
a) replace the FET (I don't have and I probably have to order it oversees)
b) leave it as is
c) remove the rest of that phase (and what should I remove)
What do you think I should do??
Pictures attached...
Comment