Announcement

Collapse
No announcement yet.

EpoX EP-MVP3G-M Super Socket 7 recap

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    EpoX EP-MVP3G-M Super Socket 7 recap

    Hi all, I'm looking to fully recap this Super Socket 7 motherboard as one of the Teyah 1000uf 6.3v caps on it has failed. Here are some pictures of the two types of caps used on the board (Teyah 1000uf 6.3v and Teyah 100uf 16v). Can you please give some suggestions on what to use as replacements? I'm located in the US and I typically order from Digikey or Mouser, but not opposed to ordering from elsewhere. Thank you!






    Last edited by airs; 05-11-2018, 12:27 PM.

    #2
    Re: EpoX EP-MVP3G-M Super Socket 7 recap

    What is the Series and the diameter of the TAYEH 1000uf caps?
    If they are 8mm in diameter these could work...
    https://www.badcaps.net/store/produc...products_id=46

    Most likely overkill for a socket 7 board.
    I can not find a data sheet for TAYEH but others say TAYEH are close to TEAPO in specs.

    Comment


      #3
      Re: EpoX EP-MVP3G-M Super Socket 7 recap

      Originally posted by Sparkey55 View Post
      What is the Series and the diameter of the TAYEH 1000uf caps?
      If they are 8mm in diameter these could work...
      https://www.badcaps.net/store/produc...products_id=46

      Most likely overkill for a socket 7 board.
      I can not find a data sheet for TAYEH but others say TAYEH are close to TEAPO in specs.
      Thank you for the reply. The diameter is 8mm on the 6.3v 1000uf caps. I’m not sure what series they are though - C925 is printed on them - is that the series?

      The diameter for the 16v 100uf caps is 5mm. Any idea what I should use to replace those?

      Comment


        #4
        Re: EpoX EP-MVP3G-M Super Socket 7 recap

        Originally posted by airs View Post
        Thank you for the reply. The diameter is 8mm on the 6.3v 1000uf caps. I'm not sure what series they are though - C925 is printed on them - is that the series?

        The diameter for the 16v 100uf caps is 5mm. Any idea what I should use to replace those?
        https://www.badcaps.net/store/produc...roducts_id=112

        Comment


          #5
          Re: EpoX EP-MVP3G-M Super Socket 7 recap

          Thanks Sparkey! So its not a problem in this case to increase the capacitance from 100uf to 220uf?

          Comment

          Working...
          X